Owner's Manual Vacuum Cleaner Model 116.20112 116.21212 CAUTION: Read and follow all safety and operating instructions before first use of this product. Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com Part No. CO 1ZAXW2QUOa-8175189 Printed in U.S.A.
Before Using Your New Vacuum ....... 2 Kenmore Vacuum Cleaner Warranty ... 2 Important Safety Instructions ......... 3 Parts and Features ................. 4-6 Assembly ........................ 6-7 Canister Care Use ................................ How to Start ........................ VacuumingTips ..................... SuggestedPile Height Settings ......... Attachments ....................... Attachment UseChart ............... PerformanceFeatures ...............
WARNING Your safety is important to us.To reduce the risk of fire, electrical shock, injury to persons or damage when using your vacuum cleaner, follow basic safety precautions including the following: Read this manual before assembling or Do not operate the cleaner with a punctured hose. The hose contains electrical wires. using your vacuum cleaner. Replace if cut or worn. Avoid picking up Use your cleaner only as described in this sharp objects. manual. Use only with Sears recommended attachments.
Itisimportant toknow yourvacuum cleaner's partsandfeatures toassure itsproper andsafe use.Review thesebefore using yourcleaner. Item PartNo. PartNo. InU.S.
ATTACHMENTS T Combination Crevice (Some Tool Brush Models) (Some Models) Fabric (Some Brush POWER-MATE (Some (Some Brush Floor Models) (Some Brush Models) TM Jr. Models) HANDhMATE (Some Floor Models) TM Jr. Models) NOTE: All models have one set of attachments in the canister. Some models have an additional set, which can be kept in the accessory bag for garage use.
Before assembling vacuum, check the PACKING LIST on the cover of the separate Repair Parts List. Use this list to verify that you have received all the components of your new Kenmore vacuum. WARNING Handle_ Electrical Shock Hazard DO NOT plug into electrical supply until assembly is complete. Failure to do so could result in electrical shock or injury. WANDS Slide wands together until wand button snaps into place. Cord Holder Cord Holder Cord Holder POWER-IVlATE TM -- Wand_ 1.
2. Insert handle into wand until lock button snaps in place. Be sure hose is not twisted. CANISTER 1. Open the canister hood. 2. Check to see that the dust bag is properly installed. See BAG CHANGING for instructions. m m 3. Check to see that the motor safety filter is properly installed. See MOTOR SAFETY FILTER CLEANING for instructions. To remove: press handle release button and pull up on handle. HOOD It is normal for the canister hood to come off when opened further than needed.
HOW TO START (Some Models) WARNING Personal Injury and Product Damage Hazard Han • DO NOT plug in if switch is in ON position. Personal injury or damage could result. • The cord moves rapidly when rewinding. Keep children away and provide a clear path when rewinding the cord to prevent personal injury. • DO NOT use outlets above counters. Damage to items in surrounding area could occur. 1. Pull cord out of canister to desired length. 2. Snap cord into grip to prevent accidental rewinding.
Suggested sweeping pattern. For best cleaning action, the POWERMATE TM should be pushed straight away from you and pulled straight back. At the end of each pull stroke, the direction of the POWER-MATE TM should be changed to point into the next section to be cleaned. This pattern should be continued across the rug with slow, gliding motions. NOTE: Fast, jerky strokes do not provide complete cleaning. The hose swivel allows the hose to turn without moving the canister.
ATTACHMENTS ON WANDS NOTE: If the POWER-MATE TM is attached, turn cleaner off before removing plug from wands. 1. To remove wands from POWER-MATE TM, lock wands in straightup position. ATTACHMENTS ON HANDLE m NOTE: if the POWER-MATE TM is attached, turn cleaner off before removing handle from wands. 2. Remove POWER-MATE TM plug and cord from holders. 1. Press lock button, then pull to remove handle from wand. 3.
EDGE CLEANER PERFORMANCE SOME MODELS Active brush edge cleaners are on both sides of the POWERMATETM. Guide either side of the POWERMATETM along baseboards or next to furniture to help remove dirt trapped at carpet edges. OVERLOAD If the performance indicator turns entirely red check for a full dust bag, or a clog in the vacuum. See HOWYOUR VACUUM WORKS.
The vacuum cleaner creates suction that picks up dirt. Rapidly moving air carries the dirt to the dust bag through the airflow passages. The dust bag lets the air pass through, while it traps the dirt. For best cleaning results, keep the airflow passage open. Check the starred areas occasionally for clogs. Unplug from outlet before checking. M_tnr Safetv Filter Filter BAG CHANGING 7. The red bag mount will flip forward after removing bag. For best cleaning results, the dust bag should be changed often.
DO NOT USE ATTACHMENTS IF THEY ARE WET. 1. Unplug cord from wall outlet. DO NOT drip water on cleaner. 2. Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water, then wrung dry. Wipe dry after cleaning. 3. To reduce static electricity and dust buildup, wipe outer surface of cleaner and attachments. Check motor safety filter occasionally and change when dirty. 1. Lift the rubber retainer and pull out motor safety filter as shown.
Exhaust\ 2. When the exhaust filter becomes dirty, remove it by pulling straight up. Filter EXHAUST FILTER ELECTROSTATIC 3. Place the new filter into the motor cover with the white side down. The electrostatic filter must be replaced when dirty. Replace the filter when the entire surface area is covered evenly. The filter CANNOT be washed as it will lose its dust trapping ability. Replacement exhaust filters are available through Sears Service Center under part no. 8175258.
! Always follow all safety precautions when cleaning and servicing the POWER-MATE TM. • WARNING Electrical Shock Or Personal Injury Hazard Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. HALF LIGHT POWER-MATE FULL LIGHT POWER-MATE TM TM ,\ 1. Remove light cover by pressing in and lifting both sides as shown. 1. Remove light cover by lifting at arrow as shown. 2.
3. Turn POWERMATE TM over. To remove cover, insert screwdriver at cover tabs on both sides and twist to release tabs. TO REPLACE Tab 4. Turn POWERMATE TM right side up. Press handle release pedal and lower the swivel. Tilt cover forward from back until front snaps free. 5. Carefully insert and twist screwdriver at each brush support to free brush from base. 6. Remove worn belt. BELT: 1. Slide washers and brush supports onto brush assembly. new belt over motor 2. Install drive, then over brush sprocket.
TO REPLACE BRUSH DOWEL: E,_ WARNING 1. Remove POWER-MATE TM cover, belt and brush assembly. See "To remove belt" in BELT CHANGING AND BRUSH CLEANING. Electrical Shock Or Personal Injury Hazard Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. 2. Remove brush supports, washers, screws, end brush, brush sprocket pieces from ends of brush assembly. 3. Reassemble brush assembly.
Review this chart to find do-it-yourself solutions for minor performance problems. Any service needed, other than those described in this owner's manual, should be performed by an authorized service representative. WARNING Electrical Shock Hazard Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury. Cleaner won't start. 1. Unplugged at wall outlet. 2. Tripped circuit breaker/blown fuse at household service panel. 3.
For repair of major brand appliances in your own home,,, no matter who made it, no matter who sold it! 1=800-4=MY=HOME® (1-800-469-4663) Anytime, day or night (U.S.A. and Canada) WWW, sears.COR'I www, Para pedir servicio de reparaci6n a sears,ca Au Canada pour service en fran_ais: 1-800-.LE=FOYER Mc domicilio, y para ordenar piezas: 1=888..SU-HOGAR sM (1-800-533-6937) www.sears.ca (1-888-784-6427) I'aomeCentral I © Sears, Roebuck and Co.
