Manual

EDGE CLEANER
Active brush edge
cleaners are on both
sides of the POWER-
MATETM. Guide either
side of the POWER-
MATETM along base-
boards or next to
furniture to help
remove dirt trapped at
carpet edges.
OVERLOAD PROTECTOR
The POWER-MATE TM has
built-in protection against
motor and belt damage
should the brush jam. If
the brush slows down or
stops, the overload
protector button pops up
and shuts off the POWER-
MATETM. The canister
motor will continue to run.
To correct problem: See
TROUBLESHOOTING.
To reset: Push in the overload protector
button.
SUCTION CONTROL
The suction control
allows you to change
the vacuum suction for
different fabric and
carpet weights. Opening
the control decreases
suction for draperies
and lightweight rugs,
while closing the control
increases suction for
upholsteries and carpets.
WARNING
Personal Injury Hazard
Always unplug the vacuum cleaner
before cleaning the brush area as
brush may suddenly restart. Failure
to do so can result in personal
injury.
PERFORMANCE INDICATOR
SOME MODELS
If the performance indi-
cator turns entirely red
check for a full dust bag,
or a clog in the vacuum.
See HOWYOUR VACUUM WORKS.
NOTE: The performance indicator may turn
red when using attachments or when clean-
ing new carpet, due to reduced airflow by
the attachments themselves or new carpet
fuzz filling the bag quickly.
POWER-MATE TM STORAGE
SOME MODELS
The lower wand has a "U" shaped flange in
the area where the power cord attaches.
The base has a "U" shaped slot near the
front caster.
The flange allows the
wands and POWER-
= MATETM to be stored
with the canister to
conserve storage
space. The canister
must be stored on end
for this feature to be
used.
The wand will slip out of the slot as it is lift-
ed up for use and will slide into the slot as it
is lowered for storage.
THERMAL PROTECTOR
This vacuum has a thermal protector which
automatically trips to protect the vacuum
from overheating. The thermal protector
turns the motor off automatically to allow the
motor to cool in order to prevent possible
damage to the vacuum.
To reset: Turn off and unplug the vacuum
from the outlet to allow the vacuum to cool.
Check for and remove any clogs. Also
check and replace any clogged filters.
Wait approximately 50 minutes and plug
the vacuum in and turn back on to see if
the thermal protector has reset. In some
cases, the unit may suddenly restart. DO
NOT leave unattended.
11