Manual

Always follow all safety precautions when performing maintenance on the PowerMate.
WARNING
Electrical Shock Or Personal Injury Hazard.
Always turn off and unplug vacuum cleaner before performing maintenance to the
vacuum cleaner, Failure to do so could result in electrical shock or personal injury from
vacuum cleaner suddenly starting.
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
1. Turn PowerMate
upside down.
2. Unscrew two (2)
PowerMate cover
screws.
3. Turn PowerMate _ -_-___
right side up. Press
handle release
pedal and lower - - _ ;;-_>,___
the swivel. Lift - _ "
rear and side __'_-"_-:_'
latches up.
Side Kear
Latch Latches
4. To remove cover,
grasp the sides and
pull out.
5. Lift agitator
assembly out
and remove
worn belt.
6. Check and clean end cap areas. See TO
CLEAN AGITATOR (page 22) section and
AGITATOR ASSEMBLYillustration(page 22)
for pictureof complete agitator assembly.
TO REPLACE BELT
I. Install new
belt over
motor drive,
then over
belt path.
Agitator End Cap
NOTE: See PARTS
AND FEATURES
(pages 5). for Belt
number.
2. Push agitator
assembly back
into PowerMate.
3. Lineup front _-___
of cover and
base. Rest __
cover on front
edge of base as
shown. Base
': "_ _ back. Press cover
n___; firmly until side
snap into place.
Side Rear
Latch Latches
Make sure there is no gap between the
cover and base.
5. Turn PowerMate upside down and re-
place two (2) cover screws.
- 21 -