Manual

Installing Storage Bins Figure 9
1. Place a Storage Bin into each Side Shelf,
See Fig. 9.
Ignitor Battery Installation - See Fig. t0
1.
2.
3.
Unscrew the Ignitor Cap located on the grill
Control Panel and remove the Contact and
Spring from the Ignitor Slot.
Place the manufacturer supplied AA battery
into the Ignitor Slot. Be sure to place the
positive pole facing toward you.
Place the Spring over the AA battery, then
place the Contact on top of the Spring.
Screw the Ignitor Cap back onto the grill
Control Panel.
Electrode Check - Requires an Assistant
Before placing the cooking components into your
gdU, ensure that the Spark Electrode Tip is
propedy positioned within each Gas Collector Box
(a 3-1/4" wide stainless mechanism found at the
front between each set of bumers.) The easiest way
to ensure this is to perform the following Electrode
Check:
1. Be sure all Control Knobs are set to OFF.
Open the Gdll Lid.
2.
Have an assistant stand behind to the dght
of the gdll and look down at each Gas
Collector Box. NEVER put your face inside
the Gdll Head.
3,
,
Press the Ignitor Cap and have the assistant
watch for a small blue spark within each
Gas Collector Box. If a spark is present the
Electrode Tips are propedy positioned.
If no spark is seen the Spark Gap shown in
Fig. 11 needs to be adjusted as follows:
• Using an adjustable wrench, loosen the Inside
Nut just until the Gas Collector Box can be
maneuvered andtumed upward.
• The gap between the Spark Electrode Tip
and the Spark Receiver should be approxi-
mately 3/16".
• If the gap iswider than 3/16" use a pair of long
nose pliers and gently squeeze the Gas Collec-
tor Box until the gap is correct.
• Return the Gas Collector Box to its original
hodzontal position, secure the Inside Nut and
try the Electrode Check again.
STORAGE BIN
Figure 10
/GNITOR SLOT
IGNITOR CAP
AABATTERY
SPRING _
CONTACT
Figure 11 - Side View
GAS COLLECTOR BOX
SPARK ELECTRODE TIP
SPARK
SPARK RECEIVER
11