Manual

As with all appliances, proper care and maintenance
willkeep yourgdll intop operating condition and
prolongits life. By following these cleaning procedures
on a timely basis, your gdll will stay clean and work
propedywith minimum effort.
CAUTION:
Be sure your gdll is OFF and cool before cleaning.
Take care not to chip or scratch the painted surfaces
because it will void yourwarranty against rusting.
Cleaning The Cooking Grids
Before initial use and periodically we suggest you wash
your cooking grids in a mild soap and warm water
solution. You can use a wash cloth or brass brush to
clean your cooking gdds.
CAUTION:
Take care not to chip orscratch the porcelain finish
because it will void yourwarranty against rusting.
Never try to clean your cooking gdds unless you are
sure the grids are cool to the touch.
Cleaning The Flame Tamers
Periodically you should wash the Flame Tamers in a
soap and warm water solution. Use a brass brush to
remove stubborn burnt-on cooking residue. Dry the
Flame Tamers thoroughly before you reinstall them into
the cooking bowl.
Cleaning The Grease Tray and Receptacle
To reduce the chance of fire, the Grease Draining Tray
and Grease Receptacle should be visually inspected
before each gdll use. Remove any grease and wash
grease tray and receptacle with a mild soap and warm
watersolution.
Annual Cleaning of The Grill Interior
Burning-off the gdll after every cookoutwill keep it
ready for instant use. However, once a year you
should give the entire gdll a thorough cleaning to keep
it in top operating condition. Follow these steps:
1. Turn all bumervalves tothe full OFF position.
2. Turn the LP gastank valve tothe full OFF position.
3. Detach the LPgas regulator assembly from yourgas
gnll.
4. Remove and clean the flame tamers, cooking gdds
and grill burners.
5. Cover each gasvalve odflcewith aluminum foil.
6. Brushthe inside and bottom ofthe grillwith a stiff
brass brush, and wash with a mild soap and warm
water solution. Rinse thoroughly and let dry.
7. Remove aluminum foil from odticos and check
each orifice for obstruction.
8. Check each spark electrode, adjusting as needed.
The space between the Spark Electrode Tip and
Spark Receiver shouldbe approximately 3/16".
9. Replace the bumem and adjustthe gas collector
box. The edge ofthe collector box should be
overlapping the burner port.
10. Replace flame tamers and the cooking grids.
11. Reconnect the gas source and observe the burner
flame for correct operation.
Cleaning Exterior Surfaces:
Before initial use, and periodically thereafter, we
suggest you wash your gdll using a mild soap and
warm water solution. You can use a wash cloth or
sponge for this process. Do not use a stiff wire or
brass brush that might remove paint during the
cleaning process.
Cleaning Exterior Stainless Steel Surfaces:
Weathering and extreme heat can cause exterior
stainless steel surfaces toturn tan in color. Use a
foam or cream Stainless Steel Cleaner to polish the
stainless steel surfaces of your grill. Never use abra-
sive cleaners or scrubbers because they will scratch
and damage your gdll. Follow these steps for the best
results.
t.
Tumthe LPgastankvalve (clockwise) tothe full OFF
position. Disconnect the regulator and hose assem-
bly from LP gastank. Cover exposed gas tiffingwith
aluminum foil.
2.
3.
Remove dirt or grease using a soft cloth and polish
stainless surfaces. Wipe with a soft cloth.
Remove aluminum foil from exposed gas tiffing and
allowgdll to air dry before attaching the regulator
and hose to your LP gas tank.
15