Installation Guide

13
Option A, Remove Access Panel - Plastic Panel
Using a flat-blade screwdriver, turn the plastic fasteners ¹⁄₄ turn
counterclockwise to unlock them. Remove panel. Do not remove
tech sheet from access panel.
Option B, Remove Access Panel - Metal Panel
Using a ¹⁄₄" nut driver or Phillips screwdriver, remove 2 screws
attaching access panel and lower panel to dishwasher.
Do not remove tech sheet from access panel.
NOTE: If using Option B, proceed to “Determine Cabinet
Opening,” to continue with more of the installation of your
dishwasher before making the direct wire connection.
Make Power Cord Connection
Option A, Power Cord
Do not disconnect the green, black, or white dishwasher wires
already attached to the terminal box. There should be adequate
length in these wires to pull the terminal box out from under the
dishwasher if you lift the wires off of the nearby clips or
components being used to keep them off the floor.
Use a ¹⁄₄" nut driver or ¹⁄₄" hex-head socket wrench to remove
the screw that holds the terminal box to the cross brace. Then,
tilt the terminal box, free the tab and lift the terminal box away
from the crossbar. Remove the cover by sliding it up and lifting
its hooks out of the slots. Retain cover for later use.
Install a UL Listed/CSA Approved metallic strain relief. Make
sure screw heads are facing up when tightening conduit nut.
Strain relief is provided with the power cord kit. See the “Tools
and Parts” section at the front of the guide for part details and
orders.