Installation Guide
14
NOTE: Route drain hose out the rear of the dishwasher.
POWER CORD CONNECTION
NOTE: If removing a previous dishwasher with a power cord,
you will need to transfer the power cord to the new dishwasher.
Use a
1
/
4
" nut driver or
1
/
4
" hex head socket wrench to remove
the screw that holds the terminal box to the cross brace. Then,
tilt the terminal box, free the tab, and lift the terminal box
away from the crossbar.
Remove the cover by sliding it up and lifting its hooks out
oftheslot. Retain cover for later use.
21. Hose clamp nal position
Stop
Stop
Drain hose stop
Drain hose
Rubber drain
hose connector
Small clamp
22. Remove terminal box
23. Remove cover
Install a UL Listed/CSA Approved metallic strain relief. Make
sure screw heads are facing up when tightening conduit
nut. Strain relief is provided with the power cord kit. See the
“Toolsand Parts” section at the front of the guide for part
detailsand orders.
Route cord so that it does not touch dishwasher motor or
lowerpart of dishwasher tub. Pull cord through strain relief
interminal box.
NOTE: A maximum of 2 power cord supply conductors
(12AWG largest size) plus 1 grounding conductor are
permitted in the terminal box.
24. Install strain relief
25. Power cord – route cord
intoterminal box