Installation Guide

15
Tighten strain relief screws to secure cord.
Place wires inside terminal box. Replace the cover by
inserting the hooks of the terminal cover into the slots in
the oor of the terminal box and sliding the cover tight
against the back wall where wires come in. Make sure
wires are tucked inside the box and not pinched by
the cover.
Put the terminal box back on the crossbar with the tab
in place. Use a
1
/
4
" nut driver and the screw removed in
Step 22 to secure the terminal box to the crossbar.
Once the terminal box has been remounted on the
dishwasher, tuck any excess length or slack over nearby
components or clip them back into the nearby clips to
help keep them o the oor.
NOTE: Route power cord out the rear of the dishwasher.
Do not plug cord into an outlet until instructed to do so.
Wiring conguration
28. Power cord – secure cord
onstrainrelief
29. Power cord – reinstall terminal
boxcover and wires
Remove the ground connector screw on the raised oor inside
the box and place it through the ring terminal of the green
ground wire of power cord. Reattach and tighten the ground
connector screw to the raised oor of the box.
Select UL Listed/CSA Approved twist-on wire connectors of
the proper size. See the “Tools and Parts” section at the front
of the guide for part details. Connect wires, black to black
and white to white, using the twist-on wire connectors.
NOTE: Do not pre-twist stranded wire. Twist on wire
connector. Gently tug on wires to be sure both are secured.
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
26. Power cord – connect ground wire
Ground
wire
Ground
wire
Ground screw
Washer
27. Power cord – connect
remainingwires