Installation Guide

17
Countertop Attachment:
Remove the brackets from the package, and insert into the
openslots on the left- and right-hand top of the dishwasher
collaras shown. Go to Step 41.
Using pliers, bend/twist tab to lock the brackets in place.
Side Attachment:
Break o the end of the bracket along the scored line
usingpliers.
37. Insert bracket
Tabs must point
to the right.
Bend tab
38. Break end of bracket
Score line
NOTE: Leave unit about 6" (152 mm) out from cabinet in
order to install anchor brackets and adjust door tension
if needed.
NOTE: Pull slack out of utilities at the same time the
dishwasher is pushed into the cabinet opening to avoid
any kinks.
CUSTOM PANEL INSTALLATION
(CUSTOM PANEL MODELS ONLY)
For custom panel installation, refer to the Custom Panel
Installation Instruction Sheet (Part Number W10750117A).
Complete custom panel installation before proceeding to
the“Choose Anchor Attachment Method” section.
CHOOSE ANCHOR ATTACHMENT METHOD
IMPORTANT: The dishwasher must be secured to the
cabinet as one of the nal steps. Prepare the dishwasher for
this by attaching the 2 brackets found in the parts bag to
thedishwasher.
– For countertops that are wood, laminate or another
similar surface, use Countertop Attachment: go to
Step 37.
– For countertops that are marble, granite, or another
hard surface, use Side Attachment: go to Step 38.
NOTE: If the gap between the top of the door and the
underside of the counter top is tight (less than
1
/
4
" [6.35 mm]),
we suggest using Side Attachment to keep from scratching
the User Interface or console with the anchor screws.
35. Move dishwasher all but 6"
(152mm) intocabinet opening
6"
(152 mm)
36. Pull slack from utilities