Ken ore MODELS 15821, 3373964 Rev. A 15825, 15828 S_ars, Roebuck _nd Co. Hotfman Estates.
Con n Dishwasher Safety .............................................................................. 3 Loading Your Dishwasher Preparing to load your dishwasher ............................... 13 America's Cleanest Dishes Loading the top rack ........................................................... 13 How the ULTRA WASH TM System works .................... 4 Removing the top rack 15 Parts and Features 5 Loading the bottom rack 15 Quick Reference Guide ...........................................
Dishwasher Your safety and the Safety safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages This is the safety alert symbol.. This symbol alerts you to hazards that can kilt or hurt you and others.. All safety messages will be preceded by the safety alert symbol and the word "DANGER" or "WARNING." These words mean: You will be killed or seriously follow instructions.
America s The ULTRA WASH Soil Removal System uses a heavy duty grinder as a food disposer to grind large food particles,. All you need to do is remove bones, large chunks, or burned-on food.. Any remaining food wi!l be ground up and disposed of by the ULTRA WASH System. You can put any dishwasher-safe iterfi in the dishwasher and expect sparkling clean results.
Parts and Feat Use this section to become familiar with the location and appearance of all parts and features.
Quick Reference Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. Electrical Shock Hazard Electrically ground dishwasher. Connect ground wire to green ground connector in terminal box. Do not use an extension cord. Failure to do so can result in death, fire, or electrical shock.
Cycle time or delay time display Signal lights Cycle pads NOTE: PF will show on the display the first time your dishwasher is connected to electricity or when electricity returns after prolonged failure.
A "J" shows what each cycle includes° CYCLE WASH MAIN WASH RINSE RINSE DRY CYCLE TIME* (MINUTES) = , QUICK RINSE Nl rl Fill 0 6 cups Detergent _ For rinsing dishes that will be washed later i i .... u uuHul.u..uuuu uu,u CHINA LIGHT Fill 1 ,I 62* cup Detergent _ A light wash and gentle dry for china and crystal. If you have not selected No Heat Dry, the heating element cycles on and off during the drying part of the cycle.
Cancel/Drain To change a cycle: o During the first two minutes of operation while filling, simply select a new cycle. OR o After the first two minutes, press Cancel/Drain, wait two minutes, and select a new cycle. (Remember to add detergent if the dishwasher has already gone through the wash portion of the cycle,) =' t ! ; i...,.i . n.iH, Automatic i i . Preprogramming Any option can be automatically preprogrammed by pressing and holding the desired option pad.
$ig sal " ° , ,un,, Water Sani Complete Heating The Water Heating fight glows to indicate the dishwasher is heating water to the proper dishwashing temperature if your household water is not hot enough NOTE: The electronic time display will pause whife this occurs° o All cycles (except Quick Rinse) automatically heat water during the final rinse.
Your Part ° Cleaning Operating your dishwasher properly enables you to obtain the best possible results, This section explains proper dishwasher operation,, o Use automatic dishwashing detergent only, Other detergents are too mild and much too sudsy. o Add detergent just before starting cycle. ° Store tightly closed detergent in a cool, dry place. Fresh automatic dishwasher detergent results in better cleaning.
Keep the rinse agent dispenser filled with a liquid rinse agent. A rinse agent greatly improves dish drying by helping water flow off them during the last rinse, A rinse agent also keeps water from forming droplets and drying as spots or streaks° To check dispenser: o Check center of fill indicator cap. Clear means it needs filling, A small amount of rinse agent automatically releases into the rinse water during the final rinse of each cycle.
L@ad ng Your D sh asher This section tells you how to load your dishwasher properly for the best washing and rinsing results. o To save water and energy, do not rinse dishes before putting them into the dishwasher. o Remove large pieces of food, bones, and other hard items. The ULTRA WASH TM module will remove food particles from the water. The module contains a chopping device which wilt reduce the size of food items.
= Do not cover third level wash o Load plastic items in the top rack only Only plastic items marked "dishwasher safe" are recommended. o Load plastic items so the force of the spray does not move them during the cycle To avoid chipping, do not let stemware touch other items.
Removethetop rackwhenyouneedmorespaceto loadtallitemsinthe bottomrack. To remove the top rack: t, Remove all toaded items from top rack. Guide rail 2_ Gently pull out and up on left end cap tab.. 3o Slide end cap up and off of guide rail. 4. Repeat Steps 1 and 2 to remove right end cap. 5. Hold top rack with both hands and pull rack forward until guide wheels are out of guide rail.. End cap tab To replace the top rack: 1. Position top rack with the rear guide wheels next to guide rails° 2.
............................ o Load items so they do not block or cover the spray tower i .. H..I..,..I Mixed load o Make sure pot handles and other items do not stop rotation of the iower spray arm_ The spray arm must move freely. o When the bottom rack is removed, replace with bumpers in front.
.................................................... i o Load the silverware basket while it is in the bottom rack or take the basket out for loading on a counter or table. NOTE: You can remove the basket for easy unloading° Always unload or remove the basket before unloading the racks to avoid spilling water droplets on the silverware° • Place small items (baby bottle caps, jar lids, etc.) in the section next to the hinged cover. Close the cover over the section to hold small items in place.
If youhaveanydoubtsaboutwashinga particularitem,checkwiththemanufacturer to seeif it is dishwasher safe, MATERIAL DISHWASHER SAFE? Aluminum Bottles Yes and Cans Cast Iron INFORMATION High water temperature and detergents may affect finish of anodized aluminum.. No Wash bottles and cans by hand. Labels attached with glue can loosen in your dishwasher. Loose labels and glue can clog spray arms or the pump and will reduce washing performance.
@ar ng ¥@ Your new dishwasher is designed to give you many years of dependable service. There are a few things you can do to maintain your dishwasher properly, This section tells you how to clean and care for your dishwasher.
6.Reconnect bothwaterinletandwateroutletto thewatersupplyvalve. 7. Emptythe panandrepositionit underthe waterpump 8. Remove the clampanddisconnect the drain hosefromthewaterpump;drainwater intopan 9, Reconnect drainhoseto thewaterpump, beingsureto positiontheclampoverthe connection. 10.Replace the loweraccesspanel.
, ,,, i,,,,,,, = Upper panel t. Insert a finger under one end of the retainer, Pull the retainer towards you in a peeling action. Set retainer aside 3, With desired color facing out, insert one side of color panel into door frame,. 2, Lift color panels at outer edges. Use one hand to • bow bottom of panel 4, Bow color panel and insert other side into ! door frame..
Access panel . Push up with thumbs on each end of access panel top trim to unsnap trim, Remove trim and set aside,, 3. With desired color facing out, slide access panel into access panel frame. % 2. Carefully slide access oanel upward and remove. Do not remove spacer. 4. Make sure access panel has slid into groove along bottom of access panel frame. 5. Line up edges of top trim with sides of access panel frame.
Thefollowingchartis a convenient checklistforhandlingminorperformance problems.Gooverthislistbefore callingforservice.If youareunableto solveyourdishwasher's problem,pleasesee"Troubleshooting." If you stillneedhelp,see"SearsRepairServices"toll-freenumbersonpage27. PROBLEM CAUSE SOLUTION Food soil left on dishes Improper loading Follow loading instructions Water temperature too low Spotting and filming is on pages 13-17o Use the Water Heat option..
PROBLEM CAUSE SOLUTION Spotting and filming (cont.) Insufficient fill caused by tow water pressure Home water pressure should be 20 to 120 psi for proper dishwasher fill. A booster pump on the water supply may be necessary if pressure is too low NOTE:To remove spots and film from dishes, try a vinegar rinse 1. Wash and rinse as usual using the Air Dry option. 2. Remove a!f metal items 3. Put 2 cups (500 mL) white vinegar in a container on the bottom rack. 4.
PROBLEM CAUSE SOLUTION Orange stains on dishwasher interior Large amounts of tomato-based foods on dishes placed in the dishwasher Stains may gradually fade over time. Regutar use of heated drying may cause stains to fade siowen Stains will not affect dishwasher performance. Regular use of Quick Rinse cycle or Air Dry option wil! reduce the likelihood of staining.. White spots on cookware with non-stick finish Seasoning removed by dishwasher detergents Reseason cookware after dishwasher washing.
T oub ÷shoo ng Please check the chart below for problems you can fix. it could save you the cost of a service call.
Forthe repair or replacement parts you need Call 7 am - 7 pm, 7 days a week (1-800-366-7278) For in-home major brand repair service Call 24 hours a day, 7 days a week (1-800-473-7247) Forthe location of a Sears Repair Service Center in your area Call 24 hours a day, 7 days a week For informationon purchasinga Sears Maintenance Agreement or to inquire about an existing Agreement Call 9 am - 5 pm, Monday - Saturday America's Repair Specialists 27
FULL ONE-YEAR WARRANTY ON DISHWASHERS For one year from the first day of use in your home, Sears will repair, free of charge, defects in materials or workmanship.