Manual

1.Restthebackcavityofthehoodonthewoodmounting
strip.
4_5 CAUTION: Hold the hood until it is completely
secured to the wood mounting strip.
Secure hood to wood strip with (4) screws #8 - 3/4" (for
30" and 36" width hoods) or (6) screws (for 42" width hood)
provided at location shown. Drill (2) 3/16" size holes into
the drywall for wall anchors through the existing holes in
the inside hood back in the locations shown. Then install
the (2) wall anchors and attach the hood to these anchors
with the remaining #8 - 3/4" screws and the (2) washers
provided.
2. Attach transition (if required) to blower rough-in plate.
Refer to page 5 for available model numbers.
Use duct tape to make all joints secure and air-tight.
Model 51600 blower plate connects directly to 7" round duct
without a transition.
Exterior blower model 57745 utilizes a model 58140
mounting plate which connects directly to 10" round ductwork
without a transition.
3. Run power cable to installation location. Refer to the
instructions included with the selected blower / rough-in
kit (sold separately) for details on installing the rough-in
plate, install the rough-in plate so that the wiring box is
located on the right side as you are facing the hood.
For ducting through back of hood, remove existing plate
from inside back of hood and attach to inside top of hood
to cover hole. Secure to threaded studs with same (4)
nuts.
For ducting through top of hood, existing plate remains in
place on inside back of hood.
Connect ducting to transition or rough-in plate as you are
installing the rough-in plate. Use duct tape to make all
joints secure and air-tight.
HD0064
HD0049
HD0063
Top of hood (inside view)
Mounting screw locations
m
m
O}
m
m
m
m
t3
O}
9 m