Manual

1. Determine whether hood will discharge vertically (3¼" x

10" or 7" Round), horizontally (3¼" x 10" only) or non-

ducted.

For vertica! or horizonta! discharge, run ductwork between

the hood location and a roof cap or wall cap.

For best results, use a minimum number of transitions and

elbows.

ROOF CAP

3¼" X 10" or

7" ROUND DUCT

(For vertical discharge)

HOUSE WIRING

or Back of hood)

24" - 30" ABOVE

COOKINGSURFACE

3¼" X 10" DUCT

(For horizontal discharge)

2. Use these diagrams for proper placement of ductwork and

electricaJ cutout in cabinet or wall.

For a non-ducted installation, DO NOT cut a duct access

hole.

3¼" X 10" 1

HOOD MOUNTING SCREWS (4) VERTICAL DUCTING

3. Run house wiring between service panel and hood

location.

t ELECTRICAL

ACCESS HOLE

WOOD SHIMS CENTER

(recessed-bottom UNE (in cabinet bottom)

cabinets only)

7" ROUND i

VERTICAL DUCTING

HOOD MOUNTING SCREWS (4)

1 015/16" (24" hood) 1 015/16" (24" hood)

1315/16" (30" hood) (30" hood)

DUCT

WOOD SHIMS t

(recessed-bottom CENTER

cabinets onmy) LmNE

ELECTRICAL

ACCESS HOLE

(in cabinet bottom)