Installation guide

Wall Sleeve Brands: #7 Whirlpool 23" Deep
Rear Loovers 10°
Top V'uew
1. Redirect the louvers at the back of the wall sleeve as shown in the
illustration. The use of pliers is recommended.
2. Attach the (2) 4½" x 3½"x 1½" foam blocks to the inside top and bot-
tom of the wall sleeve with the slots 10" from the right side wall of the
sleeve. Attach (2) Tapered Spacer Blocks behind rib on inside bottom
of the wall sleeve as shown. Taper towards the rear of the sleeve.
3. Attach 1 "x 3/4" x 14" long seal to the inside of the grille panel.
4. Install the 1/8 "x 4½"x 14" long plastic divider to the 13t¼"long.
Slide the plastic divider in the slots of the (2) foam blocks.
5. Cut to fit (1) 1',_,x 1½"x 26½"long seals as shown.
Attach (2) 1½"x 1½"x 14" long seals. Install the seals as shown.
Seals should be flush with front side of 4'/_" x 3½" x 1½ - Foam Blocks
which holds the plastic divider.
7. Install the 1- x 1',_' x 84" long stuffer seal between the wall sleeve
and the unit. A flat bladed screwdriver or putty knife is recommended.
6. Install the new
unit into the wall
sleeve. Attach
the ground wire
to the unit as
shown.
9. Assemble and install the Trim Frame. (see Trim Frame)
8