Installation Guide
2....Holding the trim kit frame in place, use a 7/64” drill bit to drill
four pilot holes into the front facing of the cutout/cabinet
through the mounting hole guides in the upper and lower
corners of the trim kit frame.
NOTES:
The holes will be drilled downward from the top, and
upward from the bottom at an angle of about 45°.
To avoid damage to the trim kit frame, do not overtighten
screws.
3. Secure trim kit frame to cutout/ cabinet by installing four long
wood screws (painted) into the pilot holes drilles in Step 2 above.
Installation is now complete. Replace any loose items that have
been removed from microwave oven cavity.
Save these installation instructions for future reference.
A. Trim kit frame C. Long wood screw (4 - painted)
B. Mounting hole guide D. Cutout ceiling
A B
C
D
EN-6