Use and Care Guide

SETTING UP VOICE CONTROL
WITH THE GOOGLE ASSISTANT
OR AMAZON ALEXA
Visit the FAQ section within the app for
instructions on how to set up Google
Assistant and Amazon Alexa with the
Kenmore robot.
Voice Commands for Your Robot:
Amazon Alexa:
“Alexa, turn on Kenmore Robot Vac.”
“Alexa, turn off Kenmore Robot Vac.”
NOTE:
You can replace “Kenmore Robot
Vac” with your robot’s name in the voice
commands above.
Google Assistant:
“Hey Google, turn on Kenmore Smart
Robot Vacuum”
“Hey Google, turn off Kenmore Smart
Robot Vacuum”
NOTE:
You can replace “Kenmore
Smart Robot Vacuum” with your robot’s
name in the voice commands above.
“24G”, “2.4” or “24” appended to the
end of the network name. For example:
“Myhomeinternet2.4”. Connect to the 2.4
GHz network before setting up your robot.
If you are experiencing trouble connecting
your robot to the Wi-Fi, there is a
secondary method available. The steps are
listed below:
AP Mode
1) Launch the Kenmore app on your
smartphone.
2) Click on 'Register'.
3) Read the Privacy Policy and select
'Agree'.
4) Enter your email address and click 'Get
Verification Code'.
5) Exit the app and check your email inbox
for a verification code. Enter the code
directly in the app.
6) Set your password and select 'Done'.
7) Select “Add Device” and tap “Kenmore
31510” on the following app interface.
8) Select “Other Mode” in the top right
corner and tap “AP Mode” on the
following app interface.
9) Press
on the robot to turn on the
robot.
NOTE:
The robot will automatically turn
on once connected to charging dock.
10) Press and hold the
button on the
robot for 6 seconds. Two audible tones
will sound and the Wi-Fi indicator light
will flash green.
11) Select "Next" button at the bottom of
the app page.
12) Select your Wi-Fi network and enter
the corresponding password of the
Wi-Fi network. Select "Confirm" to
continue.
13) Select “Go to Connect” to connect your
mobile phone to the device’s hotspot.
Connect your phone to the hotspot “SL-
Kenmore Robot-xxxx” and then go
back to the app and continue to add
devices.
14) When the robot is successfully
connected to the Wi-Fi network, an
audible tone will activate and the Wi-
Fi indicator light on the robot will
illuminate steadily. Select “Done”.
- 14 -
INSTALLATION INSTRUCTIONS