Quick Start Manual

ManualsBrandsKenmore ManualsOvensKenmore 32319

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.

iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.

READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.

if the information in this manual is not followed exactly, a fire or

explosion may result causing property damage, personal injury or death.

FOR YOUR SAFETY:

Do not store or use gasoline or other flammable vapors and liquids in

the vicinity of this or any other appliance.

WHAT TO DO iF YOU SMELL GAS:

* Do not try to light any appliance.

* Do not touch any electrical switch; do not use any phone in your building.

* immediately call your gas supplier from a neighbor's phone.

Follow the gas supplier's instructions.

* if you cannot reach your gas supplier, call the fire department.

installation and service must be performed by a qualified installer,

service agency or the gas supplier.

Appliances Installed in the

state of Massachusetts:

This Appliance can only

be installed in the state

of Massachusetts by a

Massachusetts licensed

plumber or gas fitter.

This appliance must be

installed with a three (3)

foot / 36 in. long flexible

gas connector. A "T"

handle type manual gas

valve must be installed in

the gas supply line to this

appliance.

GcIs

30" rain

Cutout Dimensions

Figure |

36" Gas Cookto 34 1,,_ 19 1/8 19 3,_

All dimensions are stated in inches and (cm).

Dimension H includes a 5" (12.7 cm) space underneath the cooktop for connection to gas supply line.

NOTE: Wiring diagrams for this cooktop are enclosed in this booklet

Printed in United States

318201491 (1004) Revo A

English - pages 1-9

Espa_ol - p6ginas 10-18

Wiring Diagram 19-20

Summary of content (20 pages)

PAGE 1
iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S READ AND SAVE THESE iNSTRUCTiONS if the information in this manual FOR FUTURE REFERENCE. is not followed explosion may result causing property damage, exactly, a fire or personal injury or death. Do not try to light any appliance. Do not touch any electrical switch; do not use any phone in your building. immediately call your gas supplier from a neighbor's phone.
PAGE 2
important Notes to the installer 1. Read all instructions contained in these 2. 3. 4. installation instructions before installing the cooktop. Remove all packing material before connecting the electrical supply to the cooktop. Observe all governing codes and ordinances. Be sure to leave these instructions with the consumer, . Note: above For operation see level, reduced 1000 ft. at 2000 appliance by 4 percent ft.
PAGE 3
0" (76.2 cm) Min. Clearance Between the Top of the Cooking Platform and Unprotected 13" (33 cm) Max. Depth For Cabinet Installed Above __detr Metal Cooktop. 18" Min. (45.7 Clearance 2" (5.1 cm) Minimum Distance Between Rear Edge of Cutout Nearest Combustible Surface Above Countertop. cm) \ ................. i 24" IV]in. (61 era) 21/4'' (5.7 cmi Min. From Counter Edge to X Front Edge of i Cutout. _ i \ ...... ..... - If a drawer is present underneath, allow at least 61/2'' (16.
PAGE 4
Typical All be Under Counter mounting hardware used to secure the Installation of an Electric Cooktop Mounted Above Side must built-in oven to the cabinets. Refer to the built-in oven installation This cooktop may be installed over certain built-in electric oven models. instructions. filler panels are to isolate the unit cabinets. Panel for installation from height necessary adjoining should of approved allow cooktop models.
PAGE 5
Typical Gas Cooktop Installation Over an Electric Built-in Oven Installed Under the Counter FRONT VIEW 18" 14_---_ [ (45.7 cm) Max. GAS COOl
PAGE 6
1. Wall Outlet Location 12" To clamp on each down, insert an angle bracket into the slot side of the unit as shown. Run thumb screw up through _1 counter. the bracket, Tighten until up against the unit the draws bottom down of and the is secure. ,__.(30.58cm) 3. Provide 12_0.3cm)-I _-_ an Adequate Gas Supply This cooktop is designed to operate of manifold pressure only. 10" on natural gas at 4" <25._,cm> A pressure regulator manifold the 120V grounded outlet on rear wall.
PAGE 7
5. install Install the regulator where Pressure pressure regulator with the arrow pointing up toward the unit in a position can the you reach The supply line must be equipped with an approved manual shutoff valve. This valve should be located in the same room as the cooktop and should be in a location that allows ease of opening and closing. Do not block access to the shutoff valve. The valve is for turning on or shutting off gas to the appliance. Regulator access on the cap.
PAGE 8
6. Electrical Requirements 7. Check Operation 120 volt, 60 Hertz, properly grounded branch circuit protected by a 15 amp circuit breaker or time delay fuse. Do not use an extension cord with this cooktop. Refer to the Use and Care Guide cooktop for operating instructions cleaning of your cooktop. Grounding 1. Remove 2. Turn on Electrical Gas Valve Instructions iMPORTANT Please read carefully. For personal grounded. safety, this appilance must be properly .
PAGE 9
4. Adjust the "LOW" burner valves setting for regular 5. Adjust the "LOW" setting of the dual burner surface valve (Figure 10) (some models): Note: On the dual valve the low setting of each portion should be adjusted individually. a. Push in and turn knob to LITE then continue to turn until only the inner portion of the dual burner stays on. b. QulckJy turn knob to LOWEST POSITIQN. c. If burner goes out, reset control to OFF. d. Remove the surface burner control knob. e.
PAGE 10
LA INSTALACION Y EL SERVICIO DEBEN SER REALIZADOS POR UN INSTALADOR CALiFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL iNSPECTOR ELECTRICO LOCAL, LEA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURAS REFERENCIAS Si todas las instrucciones de _ste manual no son observadas a la letra, se puede ocurrir incendios o e×plosiones clue pueden causar da_os materiales, lesiones o la muerte.
PAGE 11
* AsegOrese que la plancha de cocinar sea instalada y puesta a tierra correctamente pot un instalador o t_cnico calificado. Notas importantes para el instalador: I. Lea todas las instrucciones de instalaci6n antes de realizar cocinar. la instalaci6n de la plancha de * La plancha de cocinar debe conectarse el_ctricamente a tierra de acuerdo con los 2. Retire todos los art[culos de embala]e antes de realizar Jas conexiones ei6ctricas a la plancha de cocinar. 3.
PAGE 12
M6x. profundidad de gabinetes instaiados por ,q encima de la plancha de empotar es 13" (33 cm). 18" Min. (45.7 cm) \ 24" Min. (6] \ \ cm) _ _ _,, 2" (5.1 cm) Minimo Distancia entre eJ borde posterior del hueco y ia m6s cerca superficie combustible por encima dei mostrador. 21/4" (5.7cm) l Minimo ii Distancia entre el borde del mostrador y el borde del i ...... - Figura Esoacio iii i j Si hay un cai6n deba]o_ dejar ai menos 61/2'' (16.
PAGE 13
Tfpica instalaci6n de un horno el ctrico empotrado plancha de cocinar por encima Para reducJr el riesga de lesJanes personaJes ¥ incllnaci6n deJ harna de pored, _ste debe asegurarse a los gabinetes rnediante sapartes de mantaje. S6lo ciertos modelos de tapas de cocina se pueden instaiar sobre ciertos modelos de hornos eiSctricos empotrados. con una Los paneJes de reJJeno iaterales del gabinete son necesarios para aisiar ia unidad de los gabinetes adyacentes.
PAGE 14
Instalaci6n fipica de la plancha el6ctri¢o empotrado de cocinar instalado a gas por encima de un horno debajo del mostrador VISTA FRONTAL I (45.7 18"cm) _:; Max. PLANCHA DE COCINAR ' Approx. 6/2" (16.5 cm) ........
PAGE 15
1. Ubicaci6n de la toma de corriente de la pared 3. Provea un adecuado suministro de gas Esfa plancha de cocinar esf6 diseSada para utilizar natural de 4" de presi6n m61tipie solamente. gas :4_.._(30.5cm) 12" ._ J', Se conecta un regulador de presi6n en serie ai m01tiple de la plancha de cocinar y debe permanecer en serie con la linea de suministro de gas. 8" cm )'_1 (20.
PAGE 16
5, Instalaci6n del regulador El tubo de suministro de gas deberia incluir una v6ivula de cierre certiflcada. Esta v61vula deberia estar ubicada en la misrna habitaci6n de la piancha de cocinar y deberia estar en un lugar que perrnita una abertura y cierre f6ciles. No bloquee las entradas de la v61vula de cierre. La v61vula sirve para abrir o cerrar el paso del gas al artefacto.
PAGE 17
6. Requerimientos Un circuito derivado el_ctricos conectado 7. Veriflque correctamente a tierra de 120 voltios, 60 Herz protecjido par un interruptor automc_tico de 15 amp o un fusible de retardo. No ufillce un cable flexible de exiensi6n en esfa plancha de No toque a los quemadores. Pueden estar suflcientemente calientes par causar quemaduras. coclnar. Instrucclones para la puesta a tierra IMPORTANTE Par favor, 1. Qulfar 2.
PAGE 18
4, Ajus|e bajo ("LO") ara la vc_lvula de los quemadores de superncle (Figura 10) a. Presione y cjire el control hasta la posici6n LITE para prender los quemadores. b. Gire r6pldamente cjire la perilla a la POSICION MAS BAJA. c. Si el quemador se apaga0 reajuste el control a OFF. d. Retire la perilla del quemador de superficie. e. Inserte un destornillador fino-apianado en el orifico del v6stacjo de la v6ivula e inserte en el tornillo ranurado.
PAGE 19
o Z H w D -oo< _z oo< _2o J J () w z _N _ o_ _ _aP ,=_>o o _Now. 0 wwop z.z_ zo oa_ ow z w_ _<< J _ww _oca l _ _ww _ww _z J _J mNz w w =o, _z_ =_, _z_ - wz_m_< _= -03 _ >W ,,=, W g_ o . _o< zz_ _w_ zz_ _w_ =o, _z_ zz_ _wD j zz_ _w_ _ J =2 .T.I _w_ o_ _w_ d o g w _ w o co 03 c_ e3 o o o _J J_ .J _o_oJ _u w_ .... _ L''_ ...... _z_< w w wJw z
PAGE 20
m m m r++ m_ o I°+1+_°+:_1 °° m mmo omo m_ >in U++ r_ _:u mm c_z oo oco _ _J _ z r- mm zm >+4 Z>_m mm_>_ mz _m mo m_ _o Cm m_m mH _m _ cc _ m cm m_ _ _ t'lj l cm cm mm m_ P_ mz _m -0 0 op _m °N 0-0 > .. mmm_ ..