Manual

IOBLEM "
nwasher
wdl not start
Dishwasher will
not fill withwater
Unusual noise
Dishwasher
leaks
E
I
CAUSED BY
Dishwasher not
receiving electricity
Dial not in correct
position for cycle
selected
Turning the Dial
too far
Turning the Dial
too far
No water supply
Water inlet valve
clogged
Improper loading
Dishwasher not
level
Too much sudsing
Spilled rinse agent
Dishwasher door
interfereswith
surrounding
cabinets
SOLUTION
Check housefuse or circuitbreaker.
Make sure Dial is turned far enough and
cycle button is fully pushed in.
Turn Dial to START. Be careful you do not
turn the Dial any farther than necessary.
There is a delay between start-up and water
fill so you will not hear any wash action
right away.
See the solution above.
Make sure water supply valve Under sink is
turned on.
Watervalve supplyline maybe cloggedwith
sediment.Clean out.
Utensilsmay not be secureon rack pins,
or somethingsmall mayhave dropped from
the rack.Water is causingutensilsto rattle.
Make sureeverythingissecurelyplaced
in dishwasher.
Level dishwasher as described in Installation
Instructions. Don't place dishwasher on carpet.
Improper detergent. Use automatic
dishwasher detergent only or try a
different brand or less detergent.
If hand dishwashing detergent is used by
mistake, pour one measuring cup of
vegetable oil in bottom of tub and run
dishwasher through a complete NORMAL .,;_
WASH cycle with recommended amount of'
automatic dishwashing detergent.
To remove suds from tub: Open dishwasher.
Let suds evaporate. Add 1 gallon of cold
water to tub. Close and latch dishwasher.
Pump out water by slowlyturning Dial untila
drain period is reached. Repeat if neo?ssary.
Spilled j'inse agent can cause foam during
washing. This can lead to overflowing, Wipe
up accidental spill of rinse agent with a
damp cloth.
Make sure door does not touch cabinets
when opening or closing. Use levelling legs
to level dishwasher,
15