Manual
PROBLEM
Dishes not dry
Spotting and
filming
CAUSED BY SOLUTION
°Water is not hot
°NO HEAT DRY
option selected
° Improper loading
. Rinse agent
dispenser empty
• Hard water
,Water is not hot
• NO HEAT DRY
option selected
°Not enough or
poor quality
detergent
cOld detergent
,,No rinse agent
°Raise water heater thermostat to 140°F if
necessary.
°Do not select NO HEAT DRY option_
Allow dishes to dry in heated air_
oLoad dishes so items drain properly,,
Avoid overloading.
o Fill rinse agent dispenser if empty.
, Fill detergent cups to capacity. Use dishwasher
detergent with highest available phosphorous
content. May be necessary to install a water
softener_
o Raise water heater thermostat to 140°E
°Drying without heat may cause some
spotting.. Do not select NO HEAT DRY option.
• Use more fresh automatic dishwasher
detergent. Use detergent with highest
available phosphorous content, especially
if you have hard water.
oUse only fresh, automatic dishwasher
detergent° Store tightly closed in a cool, dry
place_ Discard old, lumpy or separated
detergent° Do not fill detergent dispenser
until ready to wash°
oFill rinse agent dispenser.
To remove stubborn spots and film from
glassware:
1o Remove all metal utensils from the
dishwasher.
2. Do not add detergent.
3. Select POTS PANS cycle°
4.. Start the dishwasher and allow to run for
18 to 20 minutes. The dishwasher will now
be in the main wash.
5, Then open the door and pour 2 cups
(500 ml) white vinegar into bottom of
dishwasher.
6. Close the door and allow to complete the
cycle_
If vinegar rinse doesn't work: Repeat as
above, except use 1/4 cup (60 ml) of citric
acid crystals instead of vinegar. (Most
drugstores carry citric acid crystals,)
17