Manual

PROBLEM CAUSED BY
Dishwasher • Dishwasher not
will not start receiving electricity
i.Dial not in correct
position for cycle
selected
.Turning the Dial
too far
Dishwasher will ,Turning the Dial
not fill with water too far
• No water supply
•Water inlet valve
clogged
Unus'ualnoise .improper loading
Dishwasher . Dishwasher not
leaks tevel
•Too much sudsing
•Spilled rinse agent
•Dishwasher door
interferes with
surrounding
cabinets
SOLUTION
•Check house fuse or circuit breaker,
,Make sure Dial is turned far enough and
cycle button is fulty pushed in.
•Turn Dial to START Be carefut you do not
turn the Dial any farther than necessary.
There is a delay between start-up and water
fill so you will not hear any wash action
right away,
•See the solution above
• Make sure water supply valve under sink is
turned on
•Water vaive supply line may be c_ogged with
sediment, Clean out,
• Utensils may not be secure on rack pins,
or something small may have dropped from
the rack, Water is causing utensils to rattle,
Make sure everything is securely placed
Jn dishwasher,
• Level dishwasher as described in Installation
Instructions Don't place dishwasher on carpet
• Improper detergent Use automatic
dishwasher detergent only or try a
different brand or less detergent.
• If hand dishwashing detergent is used by
mistake, pour one measuring cup of
vegetable oil in bottom of tub and run
dishwasher through a complete NORMAL
WASH cycle with recommended amount of
automatic dishwashing detergent.
,To remove suds from tub: Open dishwasher
Let suds evaporate, Add 1 gallon of cold
water to tub, Close and latch dishwasher
Pump out water by slowly turning Dial untii a
drain period is reached- Repeat if necessary,
, Spilled rinse agent can cause foam during
washing, This can lead to overflowing Wipe
up accidental spifl of rinse agent with a
damp cloth,
•Make sure door does not touch cabinets
when opening or closing Use levelling legs
to level dishwasher
15