Installation guide

Option A, Waste disposer — no air gap Option B, No waste disposer — no air gap
Waste disposer — no air gap
Large silver,
serinlets.~ .
drain hose clamp~..
As
Drain hose
“sey
Drain
trap
F
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Attach drain hose to disposer inlet
with large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
No waste disposer — no air gap
Large
silver
drain
hose
clamp
~
]. Connect black end of drain hose to
waste tee and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach black end of drain hose to
waste tee with a large silver drain
hose clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 11" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
11