Installation guide

INSTALLATION REQUIREMENTS
ape
fools and Parts
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Tools needed:
Flat-blade
screwdriver
Phillips
screwdriver GP
\
Utility knife.
y
Parts needed:
%" Compr x %4" hose
fitting. Contact your local
Sears Store to purchase
Kit Number 11000.
&y
Other parts you may also need:
Se" and V4"
nut drivers or
hex sockets
UL Listed/CSA
Approved twist-on
wire connectors*
0
=)
Small level
Measuring tape
orruler
10" adjustable wrench J! 56" open-end
that opens to wrench
T¥s" (2.9 cm)
Ah—2" Side mounting kit.) Masking or
(3.81~5 cm) for solid surface
Screw-type countertops
: (Part Number
clamps (3: maximum) 8212560)
NOTE: Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
“Electrical Requirements” section. It is recommended that
electrical connections be made by a licensed electrical
installer.
In addition, for first-time installations
Tools needed:
*Must be the proper size to connect your household wiring to
16-gauge wiring in dishwasher.
Other useful items you may need:
Flashlight > Bath towel Yee
Shallow pan Wood block
Parts supplied:
Drain hose] Drain #10-x %" 2 - under- Under -
clamps (2)..| hose Phillips-head | Counter counter
(Vlarge and screws (2); Mounting side mount
1 ven brackets (top) brackets
YG 8 «3
Make sure all these parts are included in the literature package.
Cordless drill
with 14",.34"
and 112" hole
saw bits
Small
tubing cutter| Wire stripper
Parts needed:
Copper-tubing (%" See “Electrical Requirernents” section.
heausgested) or For Direct Wire:.| For- Power Supply
water supply line use UL Listed/:..| Cord: use UL
~ CSA Approved ~| Listed/CSA
~ strain relief Approved power
to fit “”4".(2.2 cm)| supply cord kit
hole marked for-use with
dishwasher