Installation guide

Using two or more people, grasp sides of dishwasher door

frame and place dishwasher on its back.

Using a flat-blade screwdriver, turn the plastic fasteners ¹⁄₄ turn

counterclockwise to unlock them. Remove the panel. Do not

remove tech sheet from access panel.

Using a ¹⁄₄" hex head socket, nut driver or Torx

T20 screwdriver,

remove terminal box cover. Retain for later use.

Install a UL Listed/CSA Approved strain relief. Make sure

screwheads are facing to the left when tightening conduit nut.

Strain relief is provided with the power supply cord kit.

NOTE: If using Option B, proceed to “Determine Cabinet

Opening,” to continue with the installation of your dishwasher.

Make Power Supply Cord Connection

Option A, Power Supply Cord:

Route cord so that it does not touch dishwasher motor or lower

part of dishwasher tub. Pull cord through strain relief in terminal

box.