Installation guide

Built-up floors: If the kitchen floor is higher than the cabinet

opening's floor - for example, the kitchen floor tile does not

extend into the cabinet opening - add shims as needed in the

area shown to bring the dishwasher up to 33¹⁄₂" (85.1 cm) below

the countertop.

NOTE: Shims must be securely attached to floor to avoid

movement when the dishwasher is in use.

Install Door Handle

(on some models)

NOTE: The dishwasher should stay on its back for the door

handle install.

IMPORTANT: Do not scratch the front panel during this

procedure.

Remove the door handle and hardware bag containing the hex

key from the bottom rack of the dishwasher. Setscrews are

already installed in the handle. Place handle on mounting studs

with the setscrews facing down. Push the door handle tightly

against the door. Insert the short end of the hex key into the

setscrews. Tighten the setscrews ¹⁄₄ turn past snug.

Retain hex key with Installation Instructions.

Choose Attachment Option

Using 2 or more people, stand the dishwasher up.

IMPORTANT: The dishwasher must be secured to the cabinet.

There are two brackets found in the parts bag. Attach the

brackets using Option A if the countertop is wood, laminate or

another similar surface. If your countertop is marble, granite or

another hard surface, install using Option B.

Option A, Countertop Attachment

Remove the brackets from the package and insert into the open

slots on the left and right-hand top of the dishwasher collar as

shown.

Using a pair of pliers, bend the tab down to secure the bracket

in place. Repeat this step for the other side.

NOTE: Do not attach the dishwasher. This will be done later.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

dishwasher.

Failure to do so can result in back or other injury.