Installation guide

14
Connect to drain
To help minimize vibration,
route drain hose to avoid
contact with motor, door
springs, water line, cabinet,
flooring or the edge of the
hole where it passes
through the cabinet.
il
oe
Te
<
Amn
Do not remove drain loop
from side of dishwasher.
GS
oy
S&S
Ag
2-H
Dye DR eye
’ LDS rss» I
CCT
Place pan under end of
drain hose. Pan will collect
any water in drain hose.
Place the smaller drain hose clamp onto the small end of the
drain hose.
Hose clamp
4
DN wy)
Push the drain hose into the connector up to the stop on the
drain hose.
Connector Stop
wD D=On
Use pliers to open clamp and slide clamp onto connector
between stops on connector as shown.
Hose clamp
Stops
Camm Pinlbeasee eae ie eer eormmimer
secure dishwasher in cabinet opening
rei thls
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
If you have not already done so, open dishwasher door and
place towel over pump assembly and spray arm of dishwasher.
This will keep screws from falling into pump area if you
unintentionally drop them when securing dishwasher to
countertop.
Check that dishwasher is still level and centered side to side in
the opening.
Secure dishwasher to countertop or sides of cabinet with two,
#10 x Ve" Phillips-head screws. The dishwasher must be secured
to keep it from tipping when door is opened.
OR
Screw to
Screw to countertop side cabinet I
‘|
_—
Open door about 3" (7.6 cm) and check that space between
inner door and tub is equal on both sides. If spacing is not
equal, loosen bracket screws and shift tub. Tighten bracket
screws.
If using a countertop attachment to secure dishwasher, check
that top of door does not contact screws, brackets, or
countertop. If it does, dishwasher must be lowered and re-
leveled.
If securing with a side attachment, check that sides of door do
not rub against the screw heads. If they do, dishwasher must be
re-centered.
Remove towel from dishwasher.
Reinstall the lower dish rack.