Installation guide

Complete installation
J. Check that grounding clip is attached to the lower panel.
2. Place the lower panel behind the access panel. Some models
have insulation on the access panel which must fall behind the
insulation on the lower panel.
ce
Grounding
clip
3. Hold the two panels together and place them against
dishwasher leg.
4. Reinstall the screws through the holes in the access panel and
the slots in the lower panel. Install right side screw first.
5. Check that the lower edge of the lower panel contacts the
floor.
6. Tighten the screws.
Direct wire method:
AWARNING
°
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector
in terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Power supply cord method:
AWARNING
°
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in death, fire, or electrical shock.
7. Reconnect power or plug in dishwasher.
Check operation
_
Read the Use and Care Guide that came with your dishwasher.
2. Check that all parts have been installed and no steps were
skipped.
3. Check that you have all the tools you used.
4. Start dishwasher and allow it to complete the shortest wash
cycle. After the first 2 minutes, unlatch door, wait 5 seconds,
then open door.
5. Check to see that there is water in the bottom of the dishwasher
tub. Check that dishwasher is working properly.
6. If not, disconnect power or unplug dishwasher and see “If
dishwasher does not operate” section.
If dishwasher does not operate
First try the solutions suggested here to possibly avoid the cost of a
service call.
m= Has the circuit breaker tripped or the house fuse blown?
m= Is the door closed tightly and latched?
m Has the cycle been set correctly to start the dishwasher?
mls the water turned on?
If none of these work, call 1-800-4MY-HOME.