Installation guide

2. Removethe2topscrewsandthe2bottomscrews
attachingaccesspanelandlowerpanelto dishwasher
usinga1/4"hexsocket,nutdriverorPhillips
screwdriver.
3. Remove panels and set panels aside on a covered
surface.
4. Check that grounding clip is attached to the lower
panel.
grounding
clip
top
_-- screw
bottom
screw
I
bottom __ top
screw
screw
5. Apply Teflon ®_tape or pipe
joint compound to 90° elbow
fitting and connect fitting to
water inlet valve.
6. Tighten elbow until snug, and
be sure that it faces to the
rear.
water inlet valve
7. Remove terminal box cover.
- If you are direct wiring: Install a UL Listed/CSA
Approved clamp connector to the terminal box. If
using conduit, use a UL Listed!CSA Approved strain
relief.
- If you are installing a power supply cord kit, do so
now, following kit instructions. The power supply cord
kit must be UL Listed and marked for use with
dishwashers (that is, Power Supply Cord
Kit Part Number 4317824).
_ terminal
_ box cover
dishwasher wires
8.
Measure height of cabinet opening
from underside of countertop to
floor where dishwasher will be
installed (you need the lowest
point). Check chart for that height
opening. Put wheels in the
required position.
Minimum
cutout height
34" (86.4 cm)
34½" (86.7 cm)
345/16"(87.2 cm)
34½" (87.6 cm)
Wheel
position
1
2
3
4
9. Turn both front leveler legs to the same height.
front leg
Move dishwasher into cabinet opening
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1.
2.
3.
4.
5.
6.
7.
8.
Using two or more people, stand the dishwasher up.
Grasp the sides of the dishwasher
at the edges of the door panel.
Tilt dishwasher backward on wheels
and move dishwasher close to
cabinet opening. Do not push on
the front of the panel or on the
console--they may dent.
If dishwasher has a power supply
cord, insert power supply cord into hole cut into
cabinet.
If using direct wire, check that it is on the right front
side of opening.
Check that water line is on the left side of opening and
drain hose is near the center of the hole in the cabinet.
Slowly move dishwasher completely into cabinet
opening. Do not kink or pinch copper tubing, drain
hose, power supply cord or direct wire between
dishwasher and cabinet.
Helpful Tip: Once the dishwasher is in position, you
may have to support the front of the dishwasher by
raising, lowering or shimming front feet.
Remove cardboard from under dishwasher.
Using the precut slots in the insulation, attach the
insulation to the sides of the tub using the molded
hooks on each side of the tub.
NOTE: It is all right if dishwasher fits tightly into cabinet
opening. Do not remove insulation blanket--the blanket
reduces the sound level.
10
1-®Teflon is a registered trademark of E.I. Du Pont de Nemours and Company.