Installation guide

5.
Securely tighten ground connector.
ground wire
washer
ground
connector
6.
ground wire
Tighten clamp connector or
conduit connector screws.
screws
7. Reinstall terminal box cover with
wires inside terminal box.
The cover must be outside the box
on the left side.
8. Make sure no wires are pinched by cover.
Option 2, Power supply cord method
1. Route the power supply cord so that it does not touch
dishwasher motor or lower part of dishwasher tub.
2. Pull the direct wire through hole in terminal box.
Helpful Tip:
, Select the proper size twist-on
connectors to connect your household _::_ i_,
'\L}
wiring to 16-gauge dishwasher wiring.
, Insert wire ends into ULListed!CSA _ _'__
Approved twist-on connector. Do not _'_ :0' '
pre-twist bare wire.
, Twist connector.
Gently tug on wires to be sure both
are secured.
3. Connect the wires as follows using twist-on connectors
sized to connect po\/er supply cord to 16-gauge
dishwasher wire:
Power supply wire: Terminal box wire:
white--white
black--black
ground wire--ground connector
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector
in terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
4. Form bare ground wire into a U-shaped hook. Wrap
ground wire hook clockwise around ground connector
and under the washer.
5. Securely tighten ground connector.
)_,, _ _J ground wire washer
[_-_ 0 ,L__ _ .... ground
ground wire "_---_
6. Tighten clamp connector or screws
conduit connector screws.
7.
Reinstall terminal box cover with
wires inside terminal box.
The cover must be outside the box
on the left side.
i .... sT
8. Make sure no wires are pinched by cover.
9. Do not plug the dishwasher cord into the outlet until
instructed to do so.
10. Check that power supply cord does not touch
dishwasher motor or lower part of dishwasher tub.
12