Installation guide

Option D, No waste disposer — with air gap Prepare Dishwasher
No\ waste @ disposer ~ - with air gap AWARNING
Se
Air
gap
SO
po
large’drain
hose
clamp
—
Rubber hose
connector
Tip
Over
Hazard
Do not use dishwasher until completely installed.
Drain hose
Do not push down on open door.
See
C
errr
Doing so can result in serious injury or cuts.
]. Connect rubber end of drain hose
to
air
gap
and
cut
if
needed.
AWARN
ING
NOTE: Do not cut ribbed section.
Excessive Weight Hazard
2. Attach drain hose to air gap with Use two or more people to move and install
large drain hose clamp (provided). dishwasher.
Use pliers to squeeze clamp open
and move into position. If the drain
hose was cut, use a 112" to 2" (3.8 to
5 cm) screw-type clamp (not
provided).
Failure to do so can result in back or other injury.
Attach insulation
3. Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from waste
tee to air gap.
Using the precut slots in the insulation, fasten the insulation over
the molded tabs on the tub. Be sure to fasten the insulation
down on both sides of the tub.
Helpful Tip: Place cardboard under dishwasher until installed in
cabinet opening to avoid damaging floor covering. Do not use
door panel as a worktable without first covering with a towel to
avoid scratching the door panel.
1