Installation guide

‘3 | Open and close door
—
With another person holding the dishwasher to keep it from
tipping, open and close the door a few times. If the door closes
or falls open under its own weight, the door tension will need to
be adjusted.
Closes too quickly—
Decrease spring tension
me, \
2
lA eB
If the door closes too quickly, decrease the spring tension by
moving the spring end toward the front of the dishwasher.
Dy
ZZ
t
Wee
)
reg
NOTE: Springs should be in the same notches on left and right
sides.
Door falls open—
Increase spring tension
/_AP
a Ww
If the door falls open, increase the spring tension by moving the
spring end toward the back of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
Move dishwasher into
cabinet opening
Insulation
blanket NS
IMPORTANT: If rear leveling legs and spacers were removed,
cover the floor when moving the dishwasher to avoid damage
to the floor. Slowly move dishwasher completely into cabinet
opening. Do not kink or pinch water line, drain hose, power
supply cord or direct wire between dishwasher and cabinet.
Remove cardboard from under dishwasher.
NOTES:
mw Itis all right if dishwasher fits tightly into cabinet opening.
Do not remove insulation blanket — the blanket reduces the
sound level.
m= If using power cord, make sure to route end through hole in
cutout before sliding dishwasher into cabinet opening.
Align front of dishwasher
with front of cabinet doors
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your
cabinets.
17