Installation guide

Move dishwasher into cabinet opening
1. Using two or more peopb, stand the dishwasher up.
2. Grasp the sides of the dishwasher
at the edges of the door panel
3. THt dishwasher backwards on
wheeis and move dishwasher chose
to cabinet opening. Do not push on
the front of the panei or on the
consob--they may dent.
4. if dishwasher has a power suppiy
cord, insert power suppiy cord into hob cut into
cabinet.
if using direct wire, check that it is on the right front
side of opening,
5. Check that water iine is on the Heft side of opening and
drain hose is near the center of the hoie in the cabinet.
6. Slowly move dishwasher completely into cabinet
opening. Do not kink or pinch copper tubing, drain
hose, power supply cord or direct wire between
dishwasher and cabinet.
HelpfulTip: Once the dishwasher is in position, you
may have to support the front of the dishwasher by
raising, lowering or shimming front feet.
Remove cardboard from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet
opening. Do not remove insulation blanket --the blanket
reduces the sound level.
Check door spring tension
With another person holding the dishwasher to prevent it
from tipping, open and close the door a few times. If the
door closes or falls open under its own weight, the door
tension will need to be adjusted.
• If the door closes too quickly, decrease the spring
tension by moving the spring end toward the front of
the dishwasher.
• If the door falls open, increase the spring tension by
moving the spring end toward the back of the
dishwasher.
• Springs should be in the same notches on left and
right sides.
spring move
spring end
/
LeveU the dishwasher
Align front of dishwasher door panel with cabinet
doors.You may need to adjust alignment to be even
with your cabinets.
HeJpfu_Tip: Prop up one side of frame tohold
dishwasher up off floor when adjusting front legs.
With some installations, it may be easier to adjust the
front leg using the 3/16" hex head.
2. Check that leveling legs are firmly against the floor.
3. Close and latch the door, and place level against the
front panel. Check that dishwasher is plumb, if needed,
adjust leveling leg or add shims under rear wheel until
dishwasher is plumb.
f
/
J
4. Repeat for other side of dishwasher.
NOTE: Shims must be securely attached to floor to prevent
their movement when the dishwasher is operated.
5. Place level against top front
opening of tub. Check that
dishwasher is level from side to
side. If dishwasher is not level,
adjust front legs up or down until
dishwasher is level.
Make EJectricaJ Conrlection
Check "Electrical requirements" section.
You need to:
have the correct electrical supply and recommended
grounding method.
if you are:
o direct wiring, use Option 1
o using a power supply cord, use Option 2
Option 1, Direct wire method
1. Route direct wire so that it does not touch dishwasher
motor or lower part of dishwasher tub,
2. Pull direct wire through hole in terminal box,
11