Installation guide
HSITSNa
STEP
3:
PREPARE
THE
VENTING
BLOWER
Your
microwave
oven
is
shipped
with
the
blower
assembled
for
room
venting
(recirculating).
You
need
to
adjust
the
blower
if
you
want
wall
vented
or
roof
vented
installation.
A
WARNING
A
ELECTRICAL
SHOCK
HAZARD!
UNPLUG
UNIT
BEFORE
WORKING
ON
IT.
«
DO
NOT
PULL
OR
STRETCH
THE
BLOWER
WIRING!
Pulling
and
stretching
the
blower
wiring
could
result
in
electrical
shock.
A
thick,
protective
covering
REMOVE
THE
MOUNTING
PLATE:
1.
Remove
any
shipping
materials
and
parts
from
inside
the
microwave
oven.
2.
Cover
the
counter
top
or
cooktop
with
a
thick,
protective
covering
to
protect
it
from
damage
and
dirt.
See
Figure
10.
NOTE:
If
you
have
a
free-standing
range,
disconnect
it,
move
it
onto
a
piece
of
cardboard
or
hardboard
and
pull
it
away
from
the
wall,
so
that
you
can
get
closer
to
the
upper
cabinet
Mounting
and
back
wall
for
easier
measuring
and
plate
drilling.
3.
Remove
mounting
plate
2
screws
from
the
mounting
le.
Q
~
aang
plate
as
shown
and
discard
them.
(See
Figure
11.)
Mounting
plate
screws
4.
The
mounting
plate
will
also
be
used
to
locate
and
mark
the
mounting
holes
on
the
rear
wall.
5.
Locate
exhaust
adaptor,
grease
filters
and
hardware
packet.
6.
At
this
point,
remove
any
achesive
tape
(if
there
is
=
ee)
any),
on
the
exhaust
adaptor,
the
grease
filters
and
Ei
Mounting
Plate
Screws
the
power
supply
cord.
late
ROOM
VENTED
INSTALLATION:
P
Go
to
STEP
4,
PREPARE
THE
WALL
AND
UPPER
CABINET
FOR
INSTALLATION
located
on
page
13.
.
<9
(l=
t_
Control
panel
side
Figure
11
10