Installation guide

STEP 3:
PREPARE THE VENTING BLOWER
WALL VENTED INSTALLATION:
1. Remove blower unit mounting screw(s) and blower blower unit
plate screw(s). Remove the blower plate from cabinet.
See Figure 12.
back plate
blower plate
mounting screw(s)
2. Carefully lift the blower unit out of the microwave (option)
oven. Disconnect the blower wire from connector.
See Figure 13.
3. Use side cutters or tin snips to cut and remove blower plate - Q
knockouts “B" from Back plate. Discard knockouts. blower unit
Be careful not to distort the plate. See Figure 14. (ontion) screw(s)
option
4. Rotate the unit so that the exhaust ports face the rear Figure 12
of the cabinet. See Figure 15. Before you insert
blower unit, blower wire must be like Figure 15.
5. Reassemble the blower wire into the connector.
6. Place blower unit back into cabinet. Check that the
exhaust ports face towards the rear of the cabinet.
See Figure 16.
7. Reattach the blower plate to the top of the cabinet as
it was originally assembled. Attach with blower unit
mounting screw(s) and then blower plate mounting
screw(s). See Figure 17.
blower wire
8. Go to STEP 4, PREPARE THE WALL AND UPPER
CABINET FOR INSTALLATION located on page 13.
Figure 13
Figure 14
blower plate
mountin .
screw(s) (option)
blower unit
exhaust ports
exhaust :
blower unit
ports mounting screw(s) (option)
Figure 16 Figure 17
11
HSITSNa