Installation guide

PARTS, TOOLS, MATERIALS
THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Damper/duct connector
(for roof vented or wall vented installation)
One power cord clamp and
One dark-colored mounting screw
(to hold the power cord)
Four 1/4" x 2" lag screws
(for wall stud holes)
Four 1/4" x 3" toggle bolts
(for drywall holes)
Two 1/4" x 3" bolts
(for securing to the upper cabinet)
Four spring toggle heads
(for the toggle bolts)
Two tapping screws
(for attaching the damper duct connector)
©
One rear wall template
(3 pieces mounting plate only)
REAR WALL TEMPLATE
One upper cabinet template
NOTE: You need to install at least one lag screw into a 2" x 4" stud and four anchor bolts into the wall,
and the mounting area must meet the 150 Ibs. weight requirement.
HSITSNa