Manualshelf

Owners manual

ManualsBrandsKenmore ManualsAir Conditioners77135 12,000 BTU 230V Thru-the-Wall Air Conditioner - White
12345678910
8
ADDITIONAL THINGS YOU SHOULD KNOW
FAULT CODES:
If the display reads “ES” or “AS”, a sensor has failed. Contact 1-844-553-6667 for repair.
Air Directional Louvers
Air directional louvers control air flow direction. Your air
conditioner has the 4-way directional system described
below.
The louvers will allow you to direct the air flow Up or
Down and Left or Right throughout the room as needed.
Use the center handle to adjust the air directional
louvers side-to-side until the desired Left or Right
direction is obtained. Pivot horizontal louvers with your
fingertips until the desired Up/Down direction is
obtained. There are a total of 4 possible air directional
orientations available with this system.
AUTO RE-START :
After a power outage, the unit will remember the last temperature and mode settings, and will return to these same settings
once power is restored.
LOUVERS
Now that you understand the basic operation functions, here are more control features with which you should become
familiar.
The “cool” circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents
overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time.
The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees.
The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one to the
other and back, press and hold both the “TEMP/TIMER” Up( ) and Down ( ) buttons for 3 seconds.
There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility
of having to roll through to select another mode.
Evaporator coil sensor Air temperature sensor
When the unit is turned off in cool or energy saver mode, it will run in energy saver mode when it is turned on again, but
the setting of temperature and fan speed will remain.
If the unit is turned off in heat mode (if applicable) or fan only mode, it will return to the same setting when it is turned
on again.