Installation guide

important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing the wall oven.
2. Remove all packing material from the oven
compartments before connecting the electrical supply
to the wall oven.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
5. Oven door may be removed to facilitate installation.
6. THESE OVENS ARE NOT APPROVED FOR
STACKABLEOR SIDE-BY-SIDE INSTALLATION.
important Note to the Consumer
Keep these instructions with your Owner's Guide for
future reference.
IMPORTANT SAFETY
INSTRUCTIONS
• Be sure your wall oven is installed and grounded
properly by a qualified installer or service
technician.
This wall oven must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA
No.70= latest edition in United States, or with CSA
Standard C22.1, Canadian Electrical Code, Part 1,
in Canada.
Stepping, leaning or sitting on the
door of this wall oven can result in serious injuries
and can also cause damage to the wall oven.
Never use your wall oven for warming or heating
the room. Prolonged use of the wall oven without
adequate ventilation can be dangerous.
The electrical power to the oven must
be shut off while line connections are being made.
Failure to do so could result in serious injury or
death.
2. Adjusting Oven Height
Remove and lay aside the lower vent decorative trim
that is taped to the outer side panel of the oven. The
decorative trim will be fastened to the lower front of
the oven after it has been installed in the cabinet.
There is a 13A'' (4.4 cm) height adjustment on
models with extension panel (see figure 3). With this
adjustment and a 1/4"(0.6 cm) trim overhang, a single
oven can be installed in existing openings 27sA '' (70.2
cm) to 29sA '' (75.2 cm) or a double oven in existing
openings 48" (121.9 cm) to 50" or 49 7/8" (127 cm
or 126.7 cm) high.
Figure 3
%
"% 4 ........ ExtensionPanel
% Mounting Screws
To adjust oven height:
1. Lay oven on its back. (see figure 4).
2. Remove the 6 screws that fasten the side
extension panel to the bottom sides of the oven.
3. Move each panel down to the position that
increases the oven height to fit your opening.
Each position changes oven height approximately
1/2" (1.3 cm).
4. Line up the appropriate holes in the side extension
panels and sides of the oven. Put back the 6 screws.
5. Return to upright position. Proceed with oven
installation.
1. Carpentry
Refer to figure 1 or 2 for the dimensions applicable to
your appliance, and the space necessary to receive the
oven. The oven support surface may be solid plywood or
similar material, however the surface must be level from
side to side and front to rear.
OVEN DOOR
OVENBOTTOM
_NSION PANEL
Figure 4
3