Installation guide

ManualsBrandsKenmore Manualswall ovenOfficial Kenmore electric oven

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.

iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

Your new wall oven has been designed to fit a limited variety of cutout sizes to make

the job of installing easier. The first step of your installation should be to measure your

current cutout dimensions and compare them to the cutout dimensions chart below for

your model. You may find little or no cabinet work being necessary.

Canada

United States

Do not remove spacers (if equipped) on the side walls and/or on the back of the built-in oven.

These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup

that may result in heat damage or fire.

DO NOT INSTALL THIS WALL OVEN IN A BASE CABINET WITH A COUNTERTOP ABOVE IT.

NOTES:

1. Base must be capable of supporting 150 pounds (68 kg).

2. Allow at least 19 3/8" (49.2 cm) clearance for door depth when it is open.

3. Dimension G is critical to the proper

installation of the built-in oven. If the

oven decorative trim does not butt

against the cabinet, or if noise is heard

on convection models, verify dimension

G to assure it is according to the

required dimension.

4. For a cutout height greater than H

dimension see "Adjusting oven

height" section.

Door Open

(see note 2)

1 1/2"

(3.8 cm)

--%

Suggested distance from floor is 31 " (78.7 cm).

Minimum required distance is 4Y2" (11.4 cm).

Figure 1 =SINGLE OVENS

(Double Ovens see Figure 2)

Hole for cable

and electrical

junction box

on right side

3" (7.6 cm)

Max.

Electrical

Junction Box

Location

24" (61 cm) Wall Oven 22 (55.9) 22V2 (57.2)

All dimensions are stated in inches and cm.

Printed in United States

24" (61 cm) Wall Oven 23 7/8 (60.6) 31 7/16 (79.9) 213A(55.2) 25 3/16 (64)

CUTOUT DIMENSIONS AND CABINET WIDTH

MODEL Max: I G (Min:)H Max: I

23V2(59.7) 27 5/8 (70.2) 28 (71.1) 24 (61) Min

P/N 318201537 (0909) Rev. A

English - pages 1-8

Espahol- p_iginas 9-16

Summary of content (16 pages)

PAGE 1
Canada iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable and liquids in the vicinity of this or any other appliance. vapors United States Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing easier.
PAGE 2
Do not remove spacers (if equipped) on the side walls and/or on the back of the bufltqn oven. These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result in heat damage or fire. 11/2 '' (3.8 cm) Min. i -Jk Hole for cable and electrical @75/16 ''(120!2 junction box on left or right side depending on model. cm) min. 4 cm) max. 11 1/2_ Y (29.2 4. Door Open (see note 3" (7.6 cm) Max. cm) 2) Min.
PAGE 3
2. Adjusting important Notes to the Installer 1. Read all instructions contained in these installation 2. instructions before installing the wall oven. Remove all packing material from the oven compartments before connecting the electrical supply to the wall oven. 3. 4. Observe all governing codes and ordinances. Be sure to leave these instructions with the consumer. 5. 6. Oven door may be removed to facilitate installation. THESE OVENS ARE NOT APPROVED FOR STACKABLE OR SIDE-BY-SIDE INSTALLATION.
PAGE 4
3. Electrical Requirements This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse. To know the circuit breaker or fuse required by your model, see the serial plate to find the wattage consumption and refer to table A to get the circuit breaker or fuse amperage.
PAGE 5
(If your appliance is equipped with a white neutral conductor.) This appliance is manufactured with a white neutral power supply and a frame connected copper wire.
PAGE 6
5. Cabinet Installation 6. Leveling 1. 2. Do not lift the oven by[ the door handle. Heavy Weight Hazard Use 2 or more people to move and install wall oven. Failure to follow this instruction can result in injury or damage to the unit, 3. The wall oven can tip when the door is open. The anti-tip mounting screws supplied with the wall oven must be installed to prevent tipping of the wall oven and injury to persons. O Unpack the wall oven. Remove the bottom trim taped on the oven side panel.
PAGE 7
. Checking IMPORTANT NOTE: A fan inside the upper rear part above the oven (some models) provides additional cooling of the oven electrical and electronic components. The fan will continue to run after the oven has been Operation Your model is equipped with an Electronic Oven Control. Each of the functions has been factory checked before shipping. However, it is suggested that you verify the operation of the electronic oven controls once more. Refer to the Use and Care Guide for operation.
PAGE 8
Notes 8
PAGE 9
LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR Canada CAUFICADO. IMPORTANTE: GUARDE ESTAS ]NSTRUCCIONES PARA USO DEL iNSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. inflamables PARA SU SEGURIDAD: No almanece ni utilice gasolina u otros vapores y liquidos en la proximidad de este o de cualquier otro artefacto.
PAGE 10
F_ No quite los separadores (si los hay) de los muros laterales o/y de la parte posterior del homo emportado. Estos espadadores centran el horno en el espacio provisto. El horno debe estar centrado para prevenir una concentracion excesiva de calor que podria resultar en daEos por el calor o un incendio. 1 1/2" (3.8 cm) Min. Cable (a la derecha o a la izquierda seg0n el modelo). H J 111/2" (29.2 cm) _ ** PuertaAbierta (7.6 cm) Max. (vea la nota) ".s"" 2" (5.1 cm) Min.
PAGE 11
3. Ajustando Notas importantes para el instalador 1. Lea todas las instrucciones contenidas en este manual antes de instalar el homo. 2. 3. 4. 5. 6. la Altura del Horno Retire y deje a un lado la rejilla que est,1 sujeta con cinta adhesiva al panel exterior del homo. Esta rejilla se sujetar_i a la parte baja frontal del homo, despu_s de que este se haya instalado en el armario.
PAGE 12
3. Requerimientos Electricos Se debe proveer el voltaje y la frecuencia apropiados a este electrodom_stico, y conectarse a un circuito individual correctamente puesto a tierra, protegido pot un interruptor o un fusible. Para conocer el interruptor o fusible que requiere su modelo, vea la placa serial para encontrar la consumaci6n del vatiaje y refierase al cuadro A para encontrar el amperaje del interruptor o fusible. Grados de Vatios del electrodom_stico 240v Se reco_ienda I una protecci6n al .
PAGE 13
Si el horno se usa en una instalacion de circuito de ramal nuevo (1996 NEC), en una casa rodante, en un vehiculo para recreacion o si los codigos locales NO permiten la conexion a tierra a traves del cable neutral (blanco), el armazon del electrodom6stico NO TIENE QUE estar conectado al alambre neutro del sistema el6ctrico de 4 alambres (ver figura 6): 1. Desconecte el suministro el_ctrico (Si su electrodom6stico est& equipado con un conductor neutro blanco.
PAGE 14
5. Instalaci6n del Gabinete 6. Asegurese de que el homo pared esta a nivei IMPORTANTE No levante el homo pot la manija de la puerta. 1. Peligro de Peso Pesado o Use 2 personas o m_s para mover e instalar el homo de pared. Si no cumple con esta instruction, puede resultar en lesiones personales o da_os al homo de pared ODesembalar el homo de pared. Extraer la guarnici6n inferior y los 2 tornillos unidos con cinta al panel lateral del homo. 2.
PAGE 15
7. Verificacion de del funcionamiento Su modelo est_ equipado con un Control Electronico de Homo. Cada una de las funciones ha sido controlada en f_ibrica antes del despacho. Sin embargo, le sugerimos verificar el funcionamiento de los controles electr6nicos una vez m_is.Consulte la Guia de Uso y Cuidado para ver el funcionamiento del horno.
PAGE 16
Notas 16