Installation guide

ManualsBrandsKenmore Manualswall ovenOfficial Kenmore electric oven

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and Hquids in

the vicinity of this or any other appliance.

Your new wa[[ oven has been designed to fit a [imited variety of cutout sizes to make the job of installing

easier, The first step of your installation shouJd be to measure your current cutout dimensions and

compare them to the cutout dimensions chart below or next page for your mode[, You may find little or

no cabinet work will be necessary,

Do not remove spacers (if equipped) on the side walls and/or on the back of the built-in oven,

These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup

that may result in heat damage or fire.

DO NOT INSTALL THIS WALL OVEN [N A BASE CABINET WITH A COUNTERTOP ABOVE IT.

NOTES:

1. Base must be capable of supporting 150 pounds (68 kg)

2. Allow at least 19 3/8" (492 cm) clearance for door depth when it is open,

3. Dimension G is critical to the proper

installation of thebui[t-in oven. If the

oven decorative trim does not butt

against the cabinet, or if noise is heard

on convection models, verify dimension

G to assure it is according to the

required dimension.

4. For a cutout height greater than H

dimension see "Adjusting oven

height" section,

27Y/' rain.

78.7 cm) rain,

29Vs" max.

(74 crn) max.

Hole for

cable and

electrical

junction box

on right side

(7.6 cm)

Max.

* Suggested distance from floor is 31 " (78.7 cm) Junction Box

Minimum required distance is 4_z" (11.4 cm), Location

Figure 1 - SINGLE OVENS

(Double Ovens see Figure 2)

PRODUCT DIMENSIONS

MODEL ' A

24" (61 cm) Wall Oven 23 718 (60.6) 31 7116 (79.9) 21_A (55.2) 25 3116 (64}

CUTOUT DIMENSIONS AND CABINET WIDTH

24" (61 cm) Wall Oven 22 (55.9) 22V2 (572)

All dimensions are stated in inches and cm,

(Min:) I Min: H

23V2(59.7) 275/8(70.2) 28(711) 24 (61) Min

PIN 318201513 (0410) Rev C

English - pages 1-8

Espaflol - paginas 9-16

Summary of content (16 pages)

PAGE 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PAGE 2
These spacers buildup that Donotremovespacers (ifequipped) on the center The oven may the result oven in heat in the space damage provided, side walls and!or must on the be centered back of the to prevent built-in excess oven. heat or fire. 1//2 '' Hole for cable and electrical unction box on left or right side depending on model, 3" (7.6 cm) Max. (S.1 c r) Min, depending on model) NOTES 1.
PAGE 3
Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing the wall oven, 2. Remove all packing material from the oven compartments before connecting tile electrical supply to the wall oven, 3. Observe all governing (;odes and ordinances, 4. Be sure to leave these instructions with the consumer. 5. Oven door may be removed to facilitate installation. 6. THESE OVENS ARE NOT APPROVED FOR STACKABLE OR SDE-BY-SIDE INSTALLATION.
PAGE 4
To adjust oven height: 1. Lay oven on its back. (see figure 4). 2. Remove the 6 screws that fasten the side Electrical Shock Hazard • Electrical ground is required on this appliance. • Do not connect to the electrical supply until appliance is permanently grounded. • Disconnect power to the junction box before making the electrical connection.
PAGE 5
Wherelocalcodes permit connecting the appliancegrounding conductor to the neutraJ (white) wire (see figure S}: 1. Disconnect the power supply. 2. In the circuit breaker, fuse box or junction box: connect appliance and power supply cable wires as shown in Figure 5. Cable from Power Supply White Wire (Neutral) if oven is used in a new branch circuit installation (!996 NEC), mobile home, recreationaJ vehicle, or where local codes DO NOT permit grounding through the neutral (white) wire (see figure 6}: 1.
PAGE 6
HeavyWeightHazard • Use2 or morepeopleto moveand install watt oven. • Failure to follow this instruction injury or damage to the unit, 5. Cabinet can resuJt in Installation The wall oven can tip when To fasten the appliance to the cabinet: 1. Line up the 2 mounting holes on the decorative trim (ventilation) (taped to the oven side panel) with the lower mounting holes on each side of tile oven frame, below the oven door (see figure 7). 2.
PAGE 7
5. Leveling 1. the Wail Oven 2. Install an oven rack in the center of the upper oven (see Figure 9). Place a level on the rack. Take 2 readings with the level placed diagonally in one direction and then the other. Use wood shims under tile wall oven to level 3. if necessary. Repeat in the lower oven if you have a double cavity wall oven. If the level indicates that tile rack is not level, use wood shims to reach a compromise for both ovens.
PAGE 8
Notes
PAGE 9
LA mNSTALACmON Y EL SERVmCmODEBE DE HACERLOS UN mNSTALADOR CAMNCADO. mMPORTANTE: GUARDE ESTAS mNSTRUCCmONES PARA USO DEL mNSPECTOR ELECTRmCO LOCAL. LEA Y GUARDE ESTAS mNSTRUCCmONES PARA FUTURAS REFERENCmAS. PARA SU SEGURmDAD: No a[macene nJ uti[ice gaso[ina u otros vapores y [[quidos inflamab[es en [a proximidad de este o de cua[quier otto artefacto. Su nuevo homo de pared ha sido dJsehado para adaptarse a un numero diverso de huecos con dist[ntas medidas, y hater e[ trabajo de JnstaJacJ6n rnas fac[[.
PAGE 10
Noquitemos separadores (simos hay)delosmurosmaterames o/yde[aparteposterior de[homo emportado, Estos espaciadores centran emhomo en emespacio provisto. Emhomo debe estar centrado para prevenir una concentraci6n excesiva de camor que podria resumtar en daffos pot emcalor o un incendio. Cable (a la derecha o a la On el modelo) B r........
PAGE 11
Notas importantes 1. 2, 3, 4, 5, 6. 2. Requisitos para e[ insta[ador Lea todas las instrucciones contenidas en este manual antes de instalar el homo, Saque todo el material usado en el embalaje del compartimiento del horno antes de conectar el suministro electrico o de gas a la estufa, Observe todos los codigos y reglamentos pertinentes, Deje estas instrucciones con el consumidor, La puerta del horno se puede quitar para facilitar la i nstalaciOn.
PAGE 12
Para ajustar la altura del horno: 1. Ponga el horno apoyado en la pare trasera, (yea la figura 4) 2. Quite los 6 tornillos que sujetan el panel de extension lateral a la parte inferior de los lados del homo, 3. Mueva cada parle[ hacia abajo, hasta [a posici0n que aumenta [a aitura de[ horno para que se adapte a la apertura que usted tiene. Cada posicion cambia [aaltura de[ homo 1/2 pulgada (1.3 cm) aproximadamente. 4.
PAGE 13
Donde los codigos Joca[es perrnitan conectar e[ conductor de puesta a tierra de[ e[6ctrodomestico neutral (bJanco) (yea figura 5): 1, Desconecte el suministro ebctrico, 2, Si el horno se usa en una instalacion de circuito de ramal nuevo (1996 NEC), en una casa rodante, en un vehiculo para recreacion o si los codigos locales NO permiten la conexion a tierra a traves del cable neutral (blanco) (ver figura 6): 1.
PAGE 14
Peligro Para f[jar e! artefacto a los gabinetes: 1. Alinee los dos agujeros de montadura en la parrilla con los agujeros de montadura mas bajos en cada lado del armazon del horno debajo de la puerta del horno (Figura 7).
PAGE 15
6. Asegurese pared 1. esta de que el homo Asar- Cuando se pone el homo para asar, el elemento de arriba del horno debe de ponerse rojo. Limpieza (algunos mode!os)_ Cuando el horno se pone en el ciclo para que se limpia a si mismo, el elemento de arriba debe de ponerse rojo durante la parte de precalentamiento del ciclo de limpieza. Despues de que Ilegue a la temperatura adecuada de limpieza, el elemento de calentamiento inferior se encendera y debe de ponerse rojo.
PAGE 16
Notas 16