Installation guide

ManualsBrandsKenmore ManualsWall oven/microwave comboOfficial Kenmore wall oven/microwave combo

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.

iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.

READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in

the vicinity of this or any other appliance.

Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing

easier. The first step of your installation should be to measure your current cutout dimensions and

compare them to the cutout dimensions chart below for your model. You may find little or no cabinet

work is necessary.

Do not remove spacers (if equipped) on the side walls and/or on the back of the built=in

oven. These spacers center the oven in the space provided. The oven must be centered to prevent

excess heat buildup that may result in heat damage or fire.

NOTES:

1. Base must be capable of supporting 225 pounds (102 kg).

2. Allow at least 21 " (53.3 cm) clearance in front of oven for door

depth when it is open.

. Dimension G (cutout depth) is

critical to the proper installation of

the built-in oven. If the oven

decorative trim does not butt i___-----_-----------

against the cabinet verify

dimension G to assure it is the ....

required depth.

Doord_en

(seenote 2)

Suggested distance from floor .....

is 111/2" (29.2 cm).

Minimum required distance is 4

1/2"(11.4 cm)

Hole for

Cable

1" (2.5 cm) j._.._ (right or

Min. _ -'_--/left side

__ _ - _ depending

_.-i-__ L-_i,P_ ....... : onmodel)

_ ............... _ _G :

_= 4o15/16"

l J 11Y2;; _Y"\ L.-"_Fs_.._-- 3" (7.6cm)

_ (29.2 cm) '_...._k. -_ _q ..... - Max.

_ _S_acer _._q_"_, :1__ ,

....... _ ry..._ k' _._J _(3.2 cm) Electrical

(" ,---"'-_ _ ........... ,_ _Min.,,_ >f Junction Box

"\A z _bcm) vvtae vvooa_- _ (right or left side)

"\... Spacerif Needed

Figure 1

27" (68.6 cm) Wall Oven 27 (68.6) 425A (108.6) 24% (62.5) 24Y2 (62.2)

30" (76.2 cm) Wall Oven 30 (76.2) 425A (108.6) 28¼ (71.8) 24Y2 (62.2)

27" (68.6 cm) Wall Oven 247/s(63.2) 25¼(64.1) 23Y2(59.7) 41% (104.5) 41¼(104.8) 27%(68.9) Min

30" (76.2 cm) Wall Oven 28Y2 (72.4) 29 (73.7) 23Y2 (59.7) 41% (104.5) 41¼ (104.8) 30% (76.5) Min

All dimensions are stated in inches and (cm).

Printed in United States

P/N 318201518 (0711) Rev. D

English - pages 1-6

Espahol - p_iginas 7-12

Summary of content (12 pages)

PAGE 1
iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. the vicinity FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids of this or any other appliance. in Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing easier.
PAGE 2
Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing the combination oven. 2. Remove all packing material from the oven compartments before connecting the electrical supply to the wall oven. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. 5. Oven door may be removed to facilitate installation. 6 THIS COMBINATION OVEN IS NOT APPROVED FOR STACKABLE OR SIDE-BY-SIDE INSTALLATION.
PAGE 3
. Electrical Electrical Shock It is the responsibility and obligation of the consumer to contact a qualified installer to assure that the electrical installation is adequate and is in conformance with the National Electrical Code ANSI/NFPA No. 70-latest edition, or with CSA Standard C22.1, Canadian Electrical Code, Part 1, and local codes and ordinances. Hazard o Electrical ground is required on this appliance. Do not connect to the electrical supply until appliance is permanently grounded.
PAGE 4
You may not ground the oven through the neutral (white) wire if oven is used in a new branch circuit installation (1996 NEC), mobile home, recreational vehicle, or where local codes do not permit grounding through the neutral (white) wire. When grounding through the neutral (white) wire is prohibited, you must use a 4-wire power supply cable. See Figure 3. Failure to heed this warning may result in electrocution or other serious personal injury.
PAGE 5
IMPORTANT Do not lift the oven by the door handle. 4. Pushthe oven in and against the cabinet; the oven side bracket will dip into the mounting bracket installed into the side of cabinet. To pull out the oven for servicing you must use the two tools supplied with the oven. Insert one tool into hole in each side of oven frame. Holes are visible when door is " opened. After inserting tools pull the oven towards you (see Figure 6).
PAGE 6
. Leveling 1. 2. 3. the Wall 7. Checking Oven Install an oven rack in the center of the upper oven (see Figure 7). Place a level on the rack. Take 2 readings with the level placed diagonally in one direction and then the other. Use wood shims under the wall oven to level if necessary. Repeat in the lower oven if you have a double cavity wall oven. If the level indicates that the rack is not level, use wood shims to reach a compromise for both ovens.
PAGE 7
LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO. ]MPORTANTE: GUARDE ESTAS ]NSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS ]NSTRUCCIONES PARA REFERENCIA FUTURA. en la proximidad PARA SU SEGUR[DAD: No almanece ni uti[ice gaso[ina u otros vapores y I[quidos inf[amables de este o de cua[quier otto artefacto.
PAGE 8
Notas 1. 2. 3. 4. 5. 6. importantes para el instalador Grados Nota importante puerta de este horno de pared puede lesiones y da_os al horno de pared. Menosde 4100W 20A 4800W - 7200W 30A 4100W- 6200W 30A 7200W - 9600W 40A 6200W - 8300W 40A 9600Wy + 50A 8300Wy + 50A A de utilizarse ningun tipo 2. Estos electrodomesticos se deben conectar con la caja de fusibles desconectada (o interruptor) a traves del cable flexible forrado armado o no-met_ilico.
PAGE 9
Donde los c6digos locales permitan conectar el conductor de puesta a tierra del electrodom_stico neutral (blanco) (vea figura 2): 1. Desconecte el suministro el_ctrico. En cuanto alas condiciones de despacho y almacenamiento en el invierno, aseg0rese de que el homo Ilegue a su destino final como minimo tres (3) horas antes de encenderlo. Si se enciende el homo 2. cuando a0n est,1frio, se pueden dahar los controles.
PAGE 10
Si el homo se usa en una instaladon de drcuito de ramal nuevo (1996 NEC), en una casa rodante, en un vehiculo para recreacion o si los c6digos locales NO permiten la conexi6n a tierra a trav6s del cable neutral (blanco) (vet figura 3): 1. Desconecte el suministroel_ctrico 2. Separe el alambre verde (o cobre desnudo) y el alambre blanco del electrodom_stico. 3. En el interruptor autom_qtico, caja de fusibles o caja de juntas:conectar el aparato y los cables residenciales como se muestra en la figura 3.
PAGE 11
IMPORTANTE No levante el homo pot la manija de la puerta. 4. Empujar el homo hacia adentro y en contra del gabinete; la m_nsula lateral del homo enganchar_i en los soportes de montaje instalados en el lado del gabinete. Para extraer el homo en caso de reparaci6n, usar las dos herramientas provistas con el homo. Insertar una herramienta en el orificio a cada costado del marco del homo. Los orificios se pueden ver cuando la puerta est_q abierta.
PAGE 12
6. Asegurese de que el homo pared esta a nivel 1. 2. 3. 7. Verificacion de del funcionamiento Su modelo est_qequipado con un Control Electronico de Horno. Cada una de las funciones ha sido controlada en f_qbricaantes del despacho. Sin embargo, le sugerimos verificar el funcionamiento de los controles electr6nicos una vez m_qs.Consulte la Guia de Uso y Cuidado para ver el funcionamiento del horno. Instale una rejilla al centro del homo superior (vea la Figura 7).