Installation guide

Olnstall the Anti-tip MountingScrews
Thewallovencantip whenthedoor
isopen.Theanti-tipmountingscrewssupplied
with thewall ovenmustbeinstalledto prevent
tippingof thewall ovenandinjuryto persons.
A.Themountingholesinthesidetrimsmaybeused
asatemplateto locatetheappliancemountingscrew
holes(seefigure6).
B.Usethetwoscrewssuppliedto fixtheapplianceto
thecabinet.
Figure6
Olnstall the Bottom Trim
Place the top of the bottom trim over the side trim tabs
on each side of the oven below the oven door and fix
it using the 2 screws supplied in the mounting holes
located on each side trim below the oven frame (see
Figure 7).
For the double wall ovens only: If the cutout
height is between 5113116"(131.6 cm) and 511s/_6''
(131.9 cm) use the larger bottom trim.
Screws
Figure 7
-- Bottom Trim
J
6. Leveling the Wall Oven
1. Install an oven rack in the center of the upper oven
(see Figure 8).
2. Place a level on the rack. Take 2 readings with the
level placed diagonally in one direction and then the
other. Use wood shims under the wall oven to level if
necessary.
3. Repeat in the lower oven if you have a double cavity
wall oven. If the level indicates that the rack is not
level, use wood shims to reach a compromise for
both ovens.
_J
f-
Figure 8
IMPORTANT NOTE
A cooling fan inside the upper rear part
above the oven (some models} provides
cooling of the oven electrical and
electronic components. If the oven has
been operating at high temperatures, the
fan will continue to run after the oven is
turned off.
6