Manual
Table Of Contents
- KENMORE LIMITED WARRANTY
- Before setting oven controls
- Oven Controls
- Minimum & maximum control settings
- Setting the Clock
- Changing between 12 or 24 hour time of day display
- Setting Continuous Bake or 12 Hour Energy Saving
- Setting Oven Timer
- To Set Add 1 Minute Feature
- Setting the Oven Lockout
- Setting Silent Control Operation
- Setting Temperature display -- Fahrenheit or Celsius
- Operating Oven Lights
- Setting Cook Time
- Setting Delay Start
- Warm & Hold™
- Setting Bake
- Setting Broil
- Setting Convection Bake
- Setting Convection Roast
- Setting Convection Convert feature
- Setting the Slow Cook feature
- Cooking and Preparation tips for Slow Cook
- Restoring factory default settings
- Adjusting Oven Temperature
- Setting the Sabbath Feature (for use on Jewish Sabbath and Holidays)
- Self-Cleaning Operation
- Self-Cleaning Oven
- To Start the Self-Clean Cycle
- Stopping or Interrupting a Self-Cleaning Cycle
- Care and Cleaning
- Before You Call
25
Care and Cleaning
Replacing the oven light
Be sure the oven is unplugged and all parts are
cool before replacing oven light.
The interior oven lights are located at the rear of the oven cavity
and are covered with a glass shield. The glass shield must be in
place whenever the oven is in use (See Figure 14).
To replace the oven interior light bulb:
Important note:
Do not allow your fingers to touch the new bulb when replacing.
This will shorten the life of the bulb. Use a paper towel or cotton
glove while handling the new bulb when installing.
1. Turn electrical power off at the main source or unplug the
appliance.
2. Remove interior oven light shield by turning a quarter turn
counter-clockwise.
3. Replace bulb with a new T-4 type Halogen 25 watt
appliance bulb.
4. Replace glass oven light shield by rotating clockwise.
5. Turn power back on again at the main source (or plug the
appliance back in).
6. Be sure to reset the time of day on the clock.
Figure 14: Wall oven Halogen light