Manual

OPERATION
Oven Control, Clock and Timer
(Upper Oven)
Your new control has a series of tones
that will sound at different times.
These tones may sound while you set
the control for an oven function, or at
the end of the oven function. It will also
alert you that there may be a problem
with the functions. Below are the
types of tones and a brief description
of each.
TONES WHILE SETTING THE
CONTROL - When you press a touch
pad you will hear a beep. This beep
will let you know you have placed
enough pressure on the pad to
activate it. (The arrow pads do not
beep.)
END OF TIMED CYCLE TONE -
At the end of a timed cooking function,
you will hear 3 short beeps followed by
1 beep every 6 seconds. This 6
second beep will continue to sound
until the CLEAR/OFF pad is pressed
or you may select the special feature
to cancel this 6 second beep from
sounding at the end of future cycles.
TO CANCEL THE 6 SECOND
BEEP
1. Press and held the BAKE and
BROIL pads, at the same time
for 3 seconds, until the display
shows "SF."
2. Press the KITCHEN TIMER
ON/OFF pad. The display will
show "CON BEEP" (continuous
beep).
3. Press the KITCHEN TIMER
ON/OFF pad again. The display
will show "BEEP" (beep
canceled).
4. Press the START pad to cancel
the 6 second beep and leave the
special feature mode.
If you would like to return the 6 second
beep, repeat steps above until the
display shows your choice and press
the START pad.
ATTENTION TONE - This tone will
sound if you make an error or an
oversight is made while setting an
oven function.
Examples would be:
a, Setting a clean cycle and the oven
door is not properly closed.
b, Setting a function and not pressing
the START pad.
c, Pressing an additional function pad
without first setting a temperature
or time.
d, "ERR" will flash if you set an invalid
temperature. Press the
CLEAR/OFF pad to clear the
control and reset your oven function.
Any of these can be quickly identified
by watching the display.
PREHEAT TONE - When you set an
oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking.
If you set an oven function and the
control beeps while the display is
flashing "F" and a number or letter
such as "F4" or "FI," there may be a
problem with the control or oven.
Simply press the CLEAR/OFF pad
and wait about an hour. Try setting the
function again. If the code repeats,
write down the flashing code and call
for service. Tell the technician what
code was flashing.