User Manual

32
Oven Controls
Delayed Start Self Clean
To start Delay Start Self Clean:
1. Be sure the oven is empty and all oven racks are removed.
Remove all items from the cooktop. Be sure oven door is
completely closed.
2. Be sure the clock shows the correct time of day.
3. Press Delay Start.
4. Press and hold to scroll to the time desired to start
the self clean cycle. Press START when the desired start
time is displayed.
5. Press Self Clean. 3:00 appears in the display.
6. Use the numeric keys to set the time or press or
to set the desired cleaning time. The time must be
between 2:00 and 4:00.
7. After selecting the desired cleaning time, press START. Self-
cleaning is set to activate. The indicator light and
CLEAN indicator light will turn on, and the oven door will
lock before the start time. Once the start time is reached,
self-clean will start, and the time remaining will display on
the screen.
If it becomes necessary to stop Self Clean when active:
1. Press .
2. If Self Clean has heated the oven to a high temperature,
allow enough time for the oven to cool and for the indi-
cator light to turn off. When this indicator light turns off, the
oven door may be opened.
3. Restart Self Clean, if needed.
Important notes:
• If Self Clean is active and a power failure occurs, the oven
may not have thoroughly cleaned. This would depend on
how much cleaning time had elapsed before the power
failure. If needed after power is restored, set Self Clean
again.
Steam Clean
The Steam Clean feature offers a chemical free and time saving
method to assist in the routine cleaning of small and light soils.
For heavier baked on soils use the Self Clean feature.
Do not add bleach, ammonia, oven cleaner, or
any other abrasive household cleaners to the water used for
Steam Clean.
Before cleaning any part of the oven, be sure all
controls are turned off and the oven is cool. The oven may be
hot and can cause burns.
Be sure the oven is level and cool before starting Steam Clean. If
the oven temperature is above room temperature a triple beep
will be heard and the function will not start. Steam Clean
produces best results when started with a cool oven
To set a Steam Clean cycle:
1. Remove all racks and oven accessories.
2. Scrape or wipe loose debris and grease from the oven
bottom.
3. Pour 1 cup of tap water onto the oven bottom. (Figure 12)
Close oven door.
4. Press Steam Clean.
5. Press START.
STEAM CLEAN will light up in the display.
6. The time remaining in the Steam Clean cycle is shown in the
display. Do not open the door during this time. If door is
open while in Steam Clean (d-O) will appear in the display.
7. When the steam clean cycle is complete an alert will sound
and the END message will show in the display. Press STOP
to return to the clock.
8. Take care opening the door when the steam clean is
finished. Stand to the side of the oven out of the way of
escaping vapor.
9. Wipe oven cavity and bottom. Do not clean oven door
gasket (Figure 13). Avoid leaning or resting on the oven door
glass while cleaning cavity.
DOOR
STOP
STOP
DOOR
Figure 12: Add 1 cup of tap water