Owner's Manual

11
First Steps
Door Stop
Screw
Door
Stop
Washer
Hinge
Pin
Bottom
Hinge
Toe
Grille
Screws
A
Toe Grille Cover
Toe
Grille
Support
Anti-tip
Bracket
B
Toe Grille
Cover
Toe Grille
Support
Anti-tip
Bracket
7. Remove three screws on bottom hinge
and anti-tip bracket (if equipped)
with ⅜” socket wrench.
8. Install bottom hinge and anti-tip bracket
(if equipped) on opposite side with the
three screws removed from step 7.
9. Unscrew bottom hinge pin using adjustable
wrench. Move hinge pin to other hole in
hinge and tighten with adjustable wrench.
10. Reverse door handles (see Handle
Installation section).
11. Move freezer and refrigerator door
stops to opposite side. Before starting
screws, use an awl to puncture the foam.
12. Position refrigerator door onto bottom
hinge pin and screw center hinge pin
through center hinge into top of door. Close
refrigerator door to help align hinge hole.
13. Tighten center hinge pin with
adjustable wrench.
14. Remove cabinet and hinge hole plugs
and move to opposite side.
15. Lower freezer door onto center hinge pin.
16. Close freezer door. Have an assistant
lift up on opposite side of door while
tightening screws to install top hinge.
17. There are two toe grille covers
provided in your literature packet; one
for the right side and one for the left
side. Install the appropriate cover over
the opening on the side opposite the
anti-tip bracket, (see Figures A & B).
OR
Lower
Ant i-t ip
Br acket
18. Flip toe grille and reinstall (some models).
19. Plug in electrical power cord and turn
refrigerator temperature control to center
position. Adjust setting as necessary.
NOTE
In case of future door reversals, save
the toe grille cover not being used.
WARNING
When reversing the door swing:
You MUST move the anti-tip bracket
to align with the hinges of the door.
Failure to do so will result in injury.