Specifications

ManualsBrandsKenmore ManualsDishwasherKenmore Kenmore 18'' Portable Dishwasher - Black ENERGY STAR

Installation Preparation

Cabinet Preparation & Wire RoutingCabinet Preparation & Wire Routing

Cabinet Preparation & Wire Routing

• The wiring may enter the opening from either side, rear or the

floor within the shaded area.

• Cut a 1-1/2” max. dia. hole to admit the electrical cable. The

hole must be free of sharp edges. If the cabinet wall is metal,

the hole edge must be covered with a bushing.

• Cable direct connections may pass through the same hole as

the drain hose and hot water line, if convenient. If cabinet

wall is metal, the hole edge must be covered with a bushing.

NOTE: Power cords with plug must pass through a separate

hole.

Electrical Connection to DishwasherElectrical Connection to Dishwasher

Electrical Connection to Dishwasher

Electrical connection is on the right front of dishwasher.

• For cable direct connections the cable must be routed as

shown in Figure E. Cable must extend a minimum of 24” from

the rear wall.

• For power cord connections, install a 3-prong grounding type

receptacle. The power-supply receptacle for the appliance

shall be installed in a cabinet or on a wall adjacent to the

undercounter space in which the appliance is to be installed.

ARNINGARNING

ARNING

FOR PERSONAL SAFETY: Remove house fuse

or open circuit breaker before beginning

installation. Do not use an extension cord or

adapter plug with this appliance.

PREPARE ELECTRICAL WIRING

Electrical RequirementsElectrical Requirements

Electrical Requirements

• This appliance must be supplied with 120V, 60 Hz., and

connected to an individual properly grounded branch circuit,

protected by a 15 or 20 ampere circuit breaker or time delay

fuse.

• Wiring must be 2 wire with ground.

• If the electrical supply does not meet the above requirements,

call a licensed electrician before proceeding.

Grounding Instructions – Cable DirectGrounding Instructions – Cable Direct

Grounding Instructions – Cable Direct

This appliance must be connected to a grounded metal,

permanent wiring system, or an equipment grounding conductor

must be run with the circuit conductors and be connected to the

equipment grounding terminal or lead on the appliance.

GrGr

ounding Instructions – Pounding Instructions – P

ounding Instructions – P

wer Cwer C

wer C

ordord

ord

ModelsModels

Models

his appliance must be grounded. In the event of a malfunction

or breakdown, grounding will reduce the risk of electrical shock

by providing a path of least resistance for electric current. The

plug must be plugged into an appropriate outlet that is installed

and grounded in accordance with local codes and ordinances.

ARNINGARNING

ARNING

The improper connection of the equipment

grounding conductor can result in a risk of

electric shock. Check with a qualified

electrician or service representative if you

are in doubt that the appliance is

properly grounded.

White

24"

from Wall

from

Cabinet

Ground

Black

1-1/2" Dia.

Hole (Max.)

Figure E