Specifications

5
Installation Instructions
PREPPREP
PREPPREP
PREP
ARE HOARE HO
ARE HOARE HO
ARE HO
T WT W
T WT W
T W
AA
AA
A
TER LINETER LINE
TER LINETER LINE
TER LINE
• The line may enter from either side, rear or floor within the
shaded area shown in Figure F.
• The line may pass through the same hole as the electrical
cable and drain hose. Or, cut an additional 1-1/2” dia. hole
to accommodate the water line.
If power cord with plug is used, water line must not pass
through power cord hole.
Water Line ConnectionWater Line Connection
Water Line ConnectionWater Line Connection
Water Line Connection
• Turn off the water supply.
• Install a hand shut-off valve in an accessible location, such
as under the sink. (Optional, but strongly recommended and
may be required by local codes.)
• Water connection is on the left side of the dishwasher.
Install the hot water inlet line, using no less than 3/8” O.D.
copper tubing. Route the line as shown in Figure F and
extend forward at least 18” from rear wall.
• Adjust water heater for 120°F to 150°F temperature.
• Flush water line to clean out debris.
• The hot water supply line pressure must be 20-120 PSI.
CACA
CACA
CA
UTION:UTION:
UTION:UTION:
UTION:
Opening the door will cause the dishwasher
to tip forward.
Do not open theDo not open the
Do not open theDo not open the
Do not open the
door until you are ready todoor until you are ready to
door until you are ready todoor until you are ready to
door until you are ready to
install the dishwasherinstall the dishwasher
install the dishwasherinstall the dishwasher
install the dishwasher
. If . If
. If . If
. If it is
necessary to open the door, hold the
top of the dishwasher securely with one
hand and hold the door with the other
hand.
• Open the door slowly, if the door drops when released,
increase spring tension. If the door closes when released,
decrease tension.
• Pull the spring adjustment pin out of the holes, insert in the
next highest or lowest hole and test again.
• Adjust both door springs to the same tension.
• Continue moving the spring pin until door is balanced.
STEP 1 STEP 1
STEP 1 STEP 1
STEP 1
CHECK DOOR BALANCECHECK DOOR BALANCE
CHECK DOOR BALANCECHECK DOOR BALANCE
CHECK DOOR BALANCE
To check the door balance, hold the top of the dishwasher
firmly.
BEFORE YBEFORE Y
BEFORE YBEFORE Y
BEFORE Y
OU BEGINOU BEGIN
OU BEGINOU BEGIN
OU BEGIN
Locate and set aside the package containing
2 Phillips head countertop mounting screws and
2 additional toekick screws (located in the
literature package).
Cabinet Face
Shut-off
Valve
3" From Floor
18" From Wall
4"
From
Cabinet
1-1/2" Dia.
Hole
Hot
Increase
Decrease
Figure F
Figure G