Specifications
6
Installation Instructions
STEP 3STEP 3
STEP 3STEP 3
STEP 3
REMOREMO
REMOREMO
REMO
VE TVE T
VE TVE T
VE T
OEKICKOEKICK
OEKICKOEKICK
OEKICK
• Remove the 4 toekick screws. Lift off the 2 piece toekick.
• Measure installation height and dishwasher height. Extend
leveling legs out from the dishwasher base, 1/4" less than
installation height.
STEP 2STEP 2
STEP 2STEP 2
STEP 2
ADJUST LEVELING LEGSADJUST LEVELING LEGS
ADJUST LEVELING LEGSADJUST LEVELING LEGS
ADJUST LEVELING LEGS
• Move the dishwasher close to the installation location and
lay it on its back.
Adjust to
Installation
Height
Remove
4 Toekick
Screws
90°
Elbow
Fill
Hose
Thread
Seal Tape
Water
Valve
Bracket
STEP 4STEP 4
STEP 4STEP 4
STEP 4
INSTINST
INSTINST
INST
ALL 90° ELBOALL 90° ELBO
ALL 90° ELBOALL 90° ELBO
ALL 90° ELBO
WW
WW
W
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
Figure H
• Do not over tighten 90° elbow, water valve bracket could
bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.
Figure L
Figure J