Owner's Manual (Espanol)

REFRIGERATOR INSTALLATION
INSTALLATION
·To minimize noise and vibration, the refrigerator
MUST be
installed on a solidly constructed floor.
•
Carpeting and soft tile surfaces are not
recommended.
• Never install the refrigerator on a platform or
weakly supported structure.
1.
To avoid vibration, the unit must be leveled.
If
required, adjust the leveling legs to compensate
for unevenness
of the floor. The front should be
slightly higher than the rear to aid in door closing.
Leveling legs
can be turned easily by tipping the
cabinet
slightly. Turn the leveling legs clockwise
( ~ ) to raise the unit, counterclockwise ( t.,. )
to lower it.
(See
Leveling and Alignment: on page 17.)
2.
Install this appliance in an area where the
temperature
is between 55°F (13°C) and 11 ooF
(43°C.) If the temperature around the appliance is
too
low or high, cooling ability may be adversely
affected.
3. Too
small a distance from adjacent items may
result in lowered freezing capability and increased
electricity consumption charges. Allow at least 24
inches (61 em) in front of the refrigerator to open
the doors.
c
2" (5.08 em) ...., 1--
10
PRIOR TO USE
1. Clean your refrigerator thoroughly and wipe off all
dust accumulated during shipping.
2.
Install accessories such as ice cube bin, drawers,
shelves, etc., in their proper places. They are
packed together
to prevent possible damage
during shipment.
3. Let your refrigerator run for at
least 2 or 3 hours
before putting food in it. Check the
flow of cold air
in the freezer compartment to ensure proper
cooling. Your refrigerator is now ready for use.