Owner's Manual (Espanol)

FILTER
Before Replacing the Water Filter:
If the top shelf, located below the water filter,
is in the highest position, it will need to be
removed prior to
replacing the water filter.
To remove any shelf- Tilt up the front of the
shelf in the direction of 0 and lift it in the
direction
of EJ . Pull the shelf out.
It is recommended that you replace the filter
approximately
every 6 months,
when the water
filter indicator
( @ ) turns on, or when the
iceand water dispenser
noticeably decreases output.
1. Remove the old filter.
• Press the push button to
open the
filter cover.
NOTE: Replacing the filter
causes a small amount of
water (around 1 oz.
or
25 cc) to drain. Place a cup
under the
filter hole to catch
any waste.
• Pull the filter downward
and
pull out.
2. Replace with a new filter.
• Take the new filter out of it's packaging and
remove the protective cover from the a-rings.
FILTER
With filter "tabs" in the horizontal position, push
the new
filter into the manifold hole until it stops.
• Firmly lock in the filter.
The cover will click back into
place.
3. After replacing the filter, flush 2.5 gallons through
filter before use (flush for approximately
5 minutes) and check the filter for leaks.
To reset the water filter status display and
indicator
light, press and hold the Ultra Ice (Fiiter
Reset) button
for at least 3 seconds.
4. Filter Bypass Plug
Keep the filter bypass plug.
You MUST use the filter bypass
plug when a replacement filter
cartridge is not available.
Lb,CAUTION: DO NOT
operate
refrigerator without
filter or
filter plug installed.
28
NOTE: To purchase replacement water filter, visit
your
Sears store or 1-800-4MY- HOME. Also
visit us on the web at
www.sears.com/partsdirect.