Owner's Manual (Espanol)

TROUBLESHOOTING GUIDE
LIGHTS
DO NOT WORK
Check if ...
The power supply cord is unplugged.
LED interior lighting failure.
Then ...
Firmly plug the cord into a live outlet with proper voltage.
The refrigerator compartment lamp is LED interior
lighting, and service should be performed by
a qualified technician. Refer to the Light Bulb
Replacement
section.
REFRIGERATOR HAS AN UNUSUAL ODOR
Check if ••.
The Air Filter may need to be set to
the MAX setting or replaced.
VIBRATION OR RATTLING NOISE
Check If ••.
The refrigerator is not resting solidly on
the
floor.
Then ..•
Set the Air Filter to the MAX setting. If the odor does
not go away within 24 hours, the filter may need to be
replaced. See the Replacing the Air Filter section for
replacement instructions.
Then
..•
Floor
is weak or uneven or leveling legs need adjusting.
See Installation section on pages 9 and 17.
COMPRESSOR MOTOR SEEMS TO RUN TOO MUCH
Check if ••. Then ..•
The refrigerator that was replaced was an older Modern refrigerators with more storage space require more
model.
operating time. Even though this refrigerator may run more
than your older one it will still use less energy.
The room temperature is hotter than
normal.
The motor will run longer under warm conditions. At normal
room temperatures, expect your motor to run about 40% to
80% of the time. Under warmer conditions, expect it to run
even more often.
The door is opened often
or a large amount of food Adding food and opening the door warms the refrigerator.
has just been added.
It is normal for the refrigerator to run longer in order to cool the
refrigerator back down.
See the Food Storage Guide section
on page 22.
In order to conserve energy, try to get everything
you need out of the refrigerator
at once, keep food organized
so it is easy to find and
close the door as soon as the food is
removed.
The refrigerator was
recently plugged in and the The refrigerator will take up to 24 hours to cool completely.
refrigerator control was set correctly.
The refrigerator control is not set correctly for the See the AdJusting Control Settings section on page 21.
surrounding conditions.
The doors are not
closed completely. Push the doors firmly shut. If they will not shut all the way, see
Doors will not close completely below.
The back cover is dirty. A dirty back cover prevents air transfer and makes the motor
work harder.
Clean the back cover. Refer to the Care and
Cleaning section on page 32-33.
40