Owner's Manual

18
Attach main burner ignitor wire to electronic ignition module (A).
Attach side burner ignitor wire to side burner electrode (B).
Main burner ignitor
wire
Side burner ignitor
wire
Side burner
electrode
Electronic ignition
module
A
B
LP CYLINDER IS SOLD SEPARATELY. Use only with an OPD (over-fill protection device) equipped LP
cylinder. Fill and leak check the cylinder before attaching to grill and regulator (see Use & Care
section). Once cylinder has been filled and leak checked, place cylinder into hole in bottom shelf.
Make sure cylinder valve is facing right side panel. Secure cylinder with cylinder screw under bottom
shelf. Insert regulator through large hole in right side panel. See Use & Care section of this manual
to perform the “Burner Flame Check” and for important safety instructions before using.
Hook match holder onto right side panel.
19
Always keep LP cylinders in upright position
during use, transport, and storage.
Cylinder screw at rear of cart
Cylinder screw
CAUTION
Cylinder valve must face right side panel
once cylinder is attached. Failure to
install cylinder correctly may allow gas
hose to be damaged in operation,
resulting in the risk of fire.
30 · 464323113
LP Cylinder
(not included)
Regulator
Match holder
Right side panel